ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
im just after a bottom end.. low mileage if possible close to the midlands. thanks
[Edited on 28-06-2009 by ali_corsa]
[Edited on 28-06-2009 by ali_corsa]
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
up
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
ttt
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
bump
|
ckallis500
Member
Registered: 14th Dec 04
Location: plymouth
User status: Offline
|
use an xe bottom end
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
they have there differences
|
ckallis500
Member
Registered: 14th Dec 04
Location: plymouth
User status: Offline
|
yes but if you have a 2ltr 8v engine you can swap over the needed bits onto an xe bottom end which is stronger. all u will need is block with crank n pistons. then everything from the onto that block and your done..
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
i need a crank thats the thing.
|