quote:

---

Originally posted by BeArDy
Hi mate,
The reason why there are not many about as they are a total pig to do, as they cost alot on parts to make them fit, and people can have a C20let for about the same price if not cheaper. Also there are not fitting kits for V6's everything has to be hand made and can cost alot.

Cutting the bodys is really not need, just the bulkhead as there no room for the inlet system or throttle system. Also so you can get the inlet on and off.

Custom engine mount is needed, on the drivers side which need to go threw a Belt so is alittle pain in the arse.

when fitting the engine you need to Strip it total down to a bare block mount it and then add all the bits, as there is no room at all in the bay to do anything.

Now here the main Problem and the money shot
the manifolds, the front one hits the crossmember and the rear one (which is the bitch) hits the steering rack, as there is no room at all between the engine and the rack, so both manifold need custom making, which is a Nightmare. as its a matter of make a bit test it make abit more test that, reason being theres only about 3" between the block and rack and in that room you need to make a down pipe with a curve and design it to you can bolt it on.
When i was building mine i spoke to a lad who was one of the first to fit a V6 and he has to Cut his manifold off whenever he wants to take it off and reweld it back on.
mine takes 4hours to take off as i only have about 5mm of spanner movment.
To get a company to make theres your looking about £400 per manifold (only going off what a mate Brett had to pay for his Nova V6)

You will also need a F20 Gearbox and Flywheel plus a uprated clutch as they dont last long, my brand new standard vauxhall one lasted 2 months (300miles)

Cooling the engine is another people, i had head gaskets go in a week (plus another V6 corsa i know went after 3 weeks and e went back to XE) get the biggest Rad you can fit Plus spend money on good fans, i have 2 Kenlow fans which cost £60 each and are well worth every penny.

shafts again upto you, if your using the Split shaft and middle mount you going to need to make a spacer as theres a gap, otherwise the shafts will flop about.

as for Power i wouldent like to say with a C20LET as i havent been aside one, the V6 engine swop in a corsa has not got to be down to power its got to be down to wanting the engine in there, and enjoying the sound it makes (which it awsome), if it was down to power you could get a LET in there which in the long run you could get alot more power out off, where 210bhp is about the limits off a V6 without spending alot of money (unless you got NOS)

I have done loads of XE and LET's into corsas for myself and other people and i would do them again if asked, BUT i would never do another V6 again..........

any more question feel free to u2u

---

quote:

---

Originally posted by BeArDy
i wouldent say 100 times
i would be suprised if theres over 25-30 in the UK.

---

quote:

---

Originally posted by BeArDy
Lincoln is where most of them are, beacuse fozzy - Powercrazy has done all of them

they can only be maybe 5-6 more other than the ones fozzy has done

---