tang
Member
Registered: 15th Jul 04
Location: Preston, Lancashire
User status: Offline
|
hi
im having the problem of too much hot air going into my K&N Induction and am planing to fit some induction tubing but aint sure were to put it for the best flow.
the only place i see possible is to lead it straight down over the arch liner so that the air entrance is just under the bumper but i aint too keen on puttin in a easily viewed place, would be alot easier if the i had a body kit on with grill mesh but i dont
is there any alteratives ?
any ideas to reduce heat and get better air flow???
any suggestions would be great
thanks all
|
combatprojex
Member
Registered: 12th Oct 03
Location: Wellingborough Drives: Corsa 1.2 16v & proud of it
User status: Offline
|
heat sheild wrapped on the engine side of the air filter?
|
Joff
Member
Registered: 17th Oct 00
Location: Cambridgeshire
User status: Offline
|
The pipe doesn't have to be sticking out of the bottom of the bumper to be effective, but it helps.
Difference in air pressure should be enough to get the air up the tube over to your filter.
|
Nick A
Member
Registered: 28th Nov 04
Location: Hertfordshire
User status: Offline
|
on my 1.2 i have some metal tubing which i have bent to the front grill in the middle, just by the fan, has made it alot louder not sure bout nhp though
|
Joff
Member
Registered: 17th Oct 00
Location: Cambridgeshire
User status: Offline
|
Why would it make it any louder? 
|
