i have fabricated a steel section which is made from 2 pieces to give the stregnth when it gets pushed on by the tie bars and then gas welded accross just need to paint it up and throw back together. im currently making some caliper hangers for hi spec calipers to run on 256mm discs.

will be a beast when finished, is a big thick beam replacing the cross member?

heya all not updated for a while as iv been so into the build and busy racing etc. but here ia a few pics of what iv been up to withe car such as the bits iv cut welded and bought etc etc enjoy and let me know what u think.

spec so far-

engine
rebuilt c20let
3 inch top hat
3 inch pipe work
frontera intercooler
roose hoses

suspension

front
bilstein fully adjustable coil overs
poly bushed
modyfied shock to give more positive camber

rear
spax adjustable shocks
polybushed

brakes

front
hispec 4 pot billet 4's
AP Racing 2 piece discs

rear
standard drums for now
will be putting hi specs on rear

bodywork
origanely a mk1 gte but had mk2 update on front
seam welded and sealed
repainted in imperial blue
speedline alasio2 wheels

interior
gsi dash
no rear seats
integra type r recaro seats
may look at carbon door cards

















not in any perticular order but kinda gives u an idea what iv been up to. plans for the rest is to make an exhaust tidy a bit of the interior loom and fit a pair of recaro's iv had out of an integra, fit the cage get my hispec 4 pots on and sort it ready for mot, not to far away now
let me know what u think
cheers
mat

[Edited on 03-09-2008 by smartarse]