cant do much damage wiring incorrectly in a switch as there wont be a neutral to cross polarity so if you get it wrong try again until it works, lights are a pain to wire without being able to test whats what

I meant for what Sam has drew above :)

quote:

---

Originally posted by pow
The switches just cut into the live wire and when they're on deliver current down the live wire to the lights

---

The switches just cut into the live wire and when they're on deliver current down the live wire to the lights

I'm not an electrician only know the basics when it comes to electrics, I managed to fit the new switches as per my wiring diagram/the original switch wiring and it works fine.

The wiring is somewhat dodgy in this house, but meh, it's a rented house what can you do when the landlord doesn't GAF? :(

I also fitted the other switches this morning and everything seems to be working fine, touch wood. :)

Lighting switches are weird. Completely differeent to what your used to with 12VDC stuff.

Noirmally just switch the live which is why you only have Red wires (old Live colours)

Just stick em in how you think they go and if dnt work then change it.
Cant really blow anything up tbh

im no house wiring expert, but that looks ass about face to me? :boggle:

I would expect the sinlge cables to come off alone (to the ring main/light) and the 4 cables to connect to eachother, something like:



Just a guess tho.

Right I took off Switch 1 to have a look behind, now all of these wires are RED and there are 5 wires in total going to this two gang dimmer switch - 4 wires coming from behind the wall and 1 wire which interconnects as so:



I bought three switches this morning from Wickes, the one I want to fit in place of the dimmer (Switch 1) is a two gang 1/2 way switch.

From the diagram I showed above, which wires do I put in COM and 1WAY for each 'gang'? And do I need that interconnecting piece of copper wire as well?

[Edited on 25-09-2010 by Sam]

The wiring is from when the house was built, which I am guessing is from the 1960s if that helps?

Actually pretty simple to do as long as you don't mix the wires up, they're usually colour coded although may not be given the wiring's age. Most switches come with basic instructions too, just don't cheap out on foreign import switches from ebay.

How easy are these to change? We need to get 3 switches changed because they are old and shitty but the wiring in this house isn't exactly up to code (and the landlord doesn't give a shit about getting the place rewired). We want to replace all three switches to normal on/off light switches.

Here's what we've got:-

Switch 1: two dimmer dials, except they don't dim the lights just turn them on/off. One dial is connected to lights in middle of ceiling (they are 3 lightbulbs coming off one ceiling rose). The other dial is connected to two sets of 2x light bulbs which have on/off light pulls if that's the right term?

This dimmer switch is fucked and there's a lot of burnt plastic inside it (an "electrician" the landlord sent to check it out took it off the wall and that's how I seen how bad it is).

Switch 2: one dimmer dial, housing is cracked and makes the bulb flicker, if you 'flick' the housing/dial with your fingers it makes it flicker even more.

Switch 3: normal on/off switch, has two switches on it (one for landing, other for bathroom).