|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Off Day » Geek Day » PC Issue » Post Reply
|
Brett |
posted on 20th Nov 12 at 10:02 |
The LED on the board is lighting up though and it's not like I've messed around unplugging cables from the board itself. | |
Sam |
posted on 20th Nov 12 at 09:59 |
RAM, or you haven't connected the ATX12v cable to the motherboard. | |
Brett |
posted on 20th Nov 12 at 00:35 |
Removed the battery for a few hours then had another try as suggested. Still wouldn't output display through the onboard or the pci-e :( | |
Brett |
posted on 19th Nov 12 at 16:18 |
There is an LED on the board actually. | |
Dom |
posted on 19th Nov 12 at 15:51 |
willay |
posted on 19th Nov 12 at 15:19 |
^^ do it | |
Dom |
posted on 19th Nov 12 at 15:01 |
Reset the CMOS/BIOS either by the reset button/pin header or pulling the battery. And there should be an indicator on the board, either LED or speaker which should give you a clue to what is wrong with it (you'll need to look at the motherboard manual to work out what the codes mean). | |
Brett |
posted on 19th Nov 12 at 14:13 |
:lol: I don't have any spare anything mate, especially not PSU's. | |
Sam |
posted on 19th Nov 12 at 13:40 |
Go into the BIOS and change it to use onboard video, shutdown and then remove the card > turn it back on etc. | |
Brett |
posted on 19th Nov 12 at 11:49 |
I am thinking it could be the graphics card. I don't have another PCI-e one to try with. I've tried removing it and using the onboard graphics but that doesn't output anything. | |
3CorsaMeal |
posted on 19th Nov 12 at 11:47 |
Mine did this with a dodgy graphics driver, but i am quite clueless about anything else, had to get a man to put the right driver on for me :lol: | |
Brett |
posted on 19th Nov 12 at 11:44 |
If you look above willay, i've tried two different sets of RAM with same results plus I've used coretemp which indicates it's running at a healthy temp (so I read). Inside of the box, fans, everything is spotless and running fine. | |
willay |
posted on 19th Nov 12 at 11:39 |
I'd go with | |
Brett |
posted on 19th Nov 12 at 11:19 |
It's cool, serves me right for replacing something that wasn't broken in the first place. These shuttles are just a bit more aesthetically pleasing than my other machine was. | |
RichR |
posted on 19th Nov 12 at 11:12 |
My work PC did this recently and it turned out to be the PSU - replaced that and its fine now | |
Brett |
posted on 19th Nov 12 at 11:08 |
Well, I tried with different ram, removing all cards, the works. Damn thing doesn't even switch on now :lol: Needless to say, it's had a short run of a few weeks and now it's been retired to the garage. Piece of crap. | |
Sam |
posted on 17th Nov 12 at 22:12 |
OK well if the temperature side of things is alright then I'd suggest perhaps doing a Memtest on the RAM. | |
Brett |
posted on 17th Nov 12 at 20:01 |
Same system, just upgrading size of drive the lazy way :lol: | |
Dom |
posted on 17th Nov 12 at 19:46 |
Yup, with a shuttle temperatures would be the first thing i'd be checking as they are renowned for high idling and load temperatures. Use something like Core Temp for monitoring and run Prime for a few hours. As Sam mentioned, i would also give it a clean anyway. quote: Clone of a drive on the same system? Or different system? Tbh I'd be dropping the install and starting fresh. [Edited on 17-11-2012 by Dom] | |
Brett |
posted on 17th Nov 12 at 19:44 |
quote: This is the machine I cloned the drive on, managed that in the end. It's done it on both drives. quote: Had it open loads mate, it's spotless. [Edited on 17-11-2012 by Brett] | |
Sam |
posted on 17th Nov 12 at 19:34 |
Check it's not cooking the CPU (clogged up heatsink/fan) and that the inside of the Shuttle isn't caked with dust. | |
pow |
posted on 17th Nov 12 at 19:24 |
Tried swapping hard drives? | |
Brett |
posted on 17th Nov 12 at 19:04 |
Got another machine recently to use as a media centre, it's one of those shuttle cube things. Probably worth mentioning I bought it second hand from a guy who had loads of them from an office clearance. |