Ah fuck knows. Only use a flat bit anyway so presume it won't matter.

CC and gti have wider front wings

What's different? Lol.

Is it the sport type wings or the non sport type 206 wings that are a good match?

Spotted your post on there, didn't realise you we're on here.

Got a N/S 206 wing on way to see how it would fit.

quote:

---

Originally posted by Ian
evilrob did a group import on arch repair pieces, think he might have got a few extra ones.

---

I just recently got a load of these shipped over from Germany, they match the Puma arch perfectly:









The 206 wings are good, but the profile is slightly off - you can tell (but only if you know what you're looking for).

I've got a spare pair - £63.17 + postage thanks to the group buy I arranged on Project Puma:

http://www.projectpuma.com/viewtopic.php?f=65&t=19805

You wouldn't get much change from £100 normally. May consider splitting the pair £35+postage for one side.

[Edited on 29-04-2013 by evilrob]

evilrob did a group import on arch repair pieces, think he might have got a few extra ones.

That's a ridiculous coincidence!

Yes you can use 206 front wings, depends on how much you are needing to replace, if its just small patches it may be better to just repair with suitable bits of metal.

Remember its the opposite front wing of the 206 to the rear of the puma you need

[Edited on 29-04-2013 by Steve]

Seems you are right Mr G! Ill get a wing priced up then. Never heard that before, just found a thread for it on another site, looks to fit well.

quote:

---

Originally posted by Ben G
iirc the best way is to use 206 front wings as they have the same shape.

---

iirc the best way is to use 206 front wings as they have the same shape.

Ahh. I want a Fiesta Zetec S instead with knackered engine to swap it all over. Puma is so gay :(

They probably compound the issue yeah, all the rusting though goes on on that seam

Ah right, thought it was the wheel arch liners too? With them been carpet, holding water?

Yeah its caused by the seam on the inner side of the skin, make sure when youve done it seal it properly from the inside behind the rear door card

Yeah only ones are the German ones Steve? Fuck paying that much, passenger side is about 1" so can cut that out and make my own square, drivers side is whole way down, looks like ill have to make my own then eh!

quote:

---

Originally posted by willay
try u2uing Ian mate.

---

none really available, repairs are mainly done by re-constructions, only weld in fresh metal though, some people try and use filler and it comes back in a few months

try u2uing Ian mate.

Anywhere sell an arch piece?? Guy we use at work said they don't list one?? Don't want to buy a full quarter, only need drivers side. If not ill have to make my own.