nice one, im leaving early to do this job, so will contact you when im done :)

wont really be too bad a job sorting them tho eh??

dude can you give me a call regarding tomorrow too, as emma is here so currently clearing it up with her to come yours and play mechanic :lol:

not so when i wobble em its wobling thou

Dont do the bearings tight, they are supposed to have a tiny bit of play in them.

so its ok to just tighten them then good stuff

i also changed the pollen/cabin filter
no car i have ever owned has ever ever had this changed ever
there always black as fuck :lol:
its done now anyway :D

Unlucky :lol: always the same though..

I had my rear bearing tightened up in old Xe

in that case just nip them bak up again. they should have a little bit of play in them because of the sideways forces on them round corners

on a plus note i found i have the door loom to have electric heated mirrors
but the in car side of the loom there is fuck all :lol:

ahwell

but i did manage to put new std mirrors on and ditch the combo huge ones :)

[Edited on 18-03-2006 by Adam-D]

there not noisy, just have a bit of play
hmmm,. ill look into that

rear bearings can be re-tightened mate

handbrake needed a little adjustment, "i like no more than 3 clicks" :)

so i adjust it jack the back up to see if its binding it is a little so i let it off a bit

then i check the wheel itself

bollocks wheel bearing has play
both side's
so i check the front and need new pads

so after doing a handbrake i now need
2 rear bearings, shoes, cylinder and drums < might aswell kill every bird with 1 stone as its all original stuff
front disks and pads and new caliper seal kits for my new caliper's

woooo
bugger :lol: