Glasgow, provisionally sold though.

where are you located mate?

I'll have a look for the english pdf that I used.

It should fit any cdti engine, especially when yours is basically the same as the one I had it on.

Do you know of any English descriptions about this? I'm wondering if it will fit my Punto as it's a hell of a lot cheaper than a re-map...

bttt

top

Will work on any cdti, you would have to confirm the harness fits but it should be the same, if the harness doesn't fit you could either make one up or use scotch locks to attach it to the original one.

Using the connectors like i'm bundling with this one means you can put it undetectably back to standard though.

will it work on a 1.7cdti sri ?

top

ebay fees cost too much money :(

I didn't notice any difference at all.

It gives you more torque over the rev range so you don't stress the engine as much in any given situation.

All evens out.

does it reduce fuel econemy alot?

ttt

This will be going on ebay next week if there's no interest on here.

:(

Makes a massive difference, not only in power but makes the car much better to drive.

Brilliant buy for any cdti owners.

Gains afaik are claimed to be about 25% bhp and 30% torque iirc, I haven't had the car rolling roaded but can believe they figures.

ttt

Sorry jr don't want to mess you about, I'm not driving the corsa, there's a good chance I might not be able to get pictures till the weekend.

I'll try to get them asap but just to let you know.

emm can get you some pics 2morrow prob jr, its off the car now.

Its the wee box in that link above, I had that down beside the battery, then a wire from there to the left hand side of the fuel rail(looking from the front of the car) the original plug plugs into one end, the other end into the fuel rail.

You literally pull the fuel rail plug out, plug it into the connector on this, then plug that into the rail.

hi mate, intrested, any pics of where and how it fits

I have for sale a tuning box, can get pictures if needed but theres not much to see.

Been used for about a year on a 1.3cdti corsa and made a massive difference to the car.

It plugs into the connector for the fuel rail and the fuel rail.

Cannot be detected by the manufacturer (if you remove it before taking it to them obviously) and takes literally 30 seconds to fit.

It have a vauxhall 1.3cdti harness for it which I believe to be the same on all vauxhalls.

It should work with any cdti engine and I can provide instructions for fitting onto non vauxhalls, although I have only personally tested this on a vauxhall engine.

It is not one of the ebay special resistor mods.

http://www.amh-booster.de/amh2/anschluss_crd.htm

http://www.amh-booster.de/shop/catalog/product_info.php?cPath=1_33_181&products_id=436

I'm looking for about 105 delivered.

[Edited on 11-02-2007 by John]