|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Regional Groups & Events » West Midlands » newbie in need please » Post Reply
|
kartel86 |
posted on 22nd Oct 10 at 16:35 |
ok so best fing is to cut them off and getnew bolts cheers | |
Piér |
posted on 20th Oct 10 at 18:43 |
On my drivers side front seat the weld holding the nut on the underneath of the car snapped off, had to grind the bolt out and put a new one in as the bolts on mine were so threadlocked even a air tool was struggling to get the bolts out! | |
Corsa_Spragg |
posted on 20th Oct 10 at 17:36 |
would be a bit messy, and you would need some new bolts lol, but if worst comes to worst! | |
Corsa_Spragg |
posted on 20th Oct 10 at 17:25 |
or you could weld a piece metal across it, and use that as leverage. | |
kartel86 |
posted on 20th Oct 10 at 17:11 |
ive tried to get them off by putting a bigger size in it but keeps rounding as they are ft and i dont think a screwdriver will work mate thanks im seriously stuck lol | |
thegsi |
posted on 20th Oct 10 at 17:07 |
Or hacksaw a line through the middle of it then loosen with a flat ended screwdriver. | |
Corsa_Spragg |
posted on 20th Oct 10 at 17:01 |
best thing to do mate is get a smaller size socket, hammer it on to make it fit, then your away! | |
kartel86 |
posted on 20th Oct 10 at 16:57 |
hi iv got a corsa project at the moment but ive tried to get the front seats out but i rounded the bolts can anyone find time to come help me out please |