i've noticed my bonnet vent mesh has kinda faded and is going rusty round the edges where it goes under the bonnet skin dunno where the guy got it from but it looks kinda sh*te u notice the difference with the new mesh on my bumper

nah man ma stuff still looks good :P

order from CARISMA £15 a sheet

aye but ur stuff will go all shitty an rust after a whiel no doubt.

stuff i got from motorworld is shiney as fuck .

nah thats whats on mine the noo. i done 2 rear bumpers and 2 fronts and still got a bit left over.

:lol: aj thats prolly chicken wire

lol m8 can get the same size sheet for £3 at grahams builders merchants :P

nevermind aj get your arse down to XS motorsport they've got a crail deal on 1250mm x 200mm £19.95 mesh that should do your motor mate advertised in the yellow paper

how expensive is expensive????

trying to say ma stuff aint good enough eh??? :P

was in a place that done it, think it was jewsons in irvine and they done it really fine stuff but was really expensive cos you had to buy the big huge sheets.

so i know aj, just trying to hunt for some a wee bit finer first.

Cheers peeps.... i'll have a look in motorworld???? and xs motorsport.

:)

told you where i got from

XS motorsprot are advertising EXTRA long mesh in the adtrader i reckon your in there m8

Go to ur nearest motorworld.

Big sheet for 15 quid. top notch stuff. Used it for my combat 2 front and rear bumpers.

doesnt rust or anythin,.

nope none in at moment , reminds me a need to get some :lol:

you not got some cunt ;) ???

none of the places above will sell it

By the sounds of it, it wont fit :(

cheers mate :)

the stuff at XS just covered the gap in my Combat bumper (not the wide arch) so i really doubt it'll do yours mate try anyway

sg bodyworx is in dreghorn is it not????
if it is, then it aint got any!

I'll try xs but as far as i am aware..... no cunt seems to sell stuff at least 130cm long!!! :mad:

xs motorsport in hamilton.koncept developments in glasgow should get u it or sg bodyworx in ayr

Anyone know where i can get some mesh from.

I've checked with george from stylingfx or whaatever its called in irvine but he's been waiting on a big delivery of the stuff from london for months now.

The bits sold in halfords and B&Q are too wee. :(