|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Interior » Post Reply
|
the_legend_of_yrag |
posted on 23rd Oct 03 at 16:16 |
Yea if you want to do it all id get two cans of each, also use cobras guide as well, in turorials and faq!! | |
Graham |
posted on 21st Oct 03 at 20:45 |
rite got the all clear for tomoz, startin on summin small such as the ash tray and its 3 for 2 in Halfords on Primer, Laquer, Paint wayhey | |
stuyw |
posted on 21st Oct 03 at 13:37 |
get some1 off here to host them for u m8 :) | |
Graham |
posted on 21st Oct 03 at 13:35 |
yeh ill do what the_legend_of_yrag ses, one step a day. so if it all goes well pics will be on here. o btw where can i host pics on the net | |
stuyw |
posted on 21st Oct 03 at 13:23 |
as i said before, just take ur time m8 n u'll be ok :thumbs: | |
Graham |
posted on 21st Oct 03 at 13:17 |
yeh jus read it lol didnt think it were that easy well i got a week to do the job lol | |
stuyw |
posted on 21st Oct 03 at 12:46 |
u can buy the max power haynes manual for more info. the glovebox handle just sprises off :) | |
Graham |
posted on 21st Oct 03 at 12:27 |
im planning to start sprayin over the half term but ive never done n e thin like this before so how easy is it to be fair. i know where most stuff is to take off over than the glove box handle??? i want it to look like JW pic over than the main dash (bove the steering colum and wheel) cheers | |
the_legend_of_yrag |
posted on 20th Oct 03 at 16:27 |
also i allowed myself 3 days to do it in. A good day with wet n dry to get a smooth surface, then spraying the primer on. Second day started painting, and third day lacqured it all. | |
Hazzle |
posted on 20th Oct 03 at 16:11 |
sounds like a plan cheers guys | |
the_legend_of_yrag |
posted on 20th Oct 03 at 15:14 |
it's not hard at all ive had everything off 3 or 4 times now and to get all the parts off i mentioned now would only take 30-45 minutes! | |
Hazzle |
posted on 20th Oct 03 at 15:10 |
Ive got a mettalic grey corsa b | |
the_legend_of_yrag |
posted on 20th Oct 03 at 13:33 |
actually it was tetrosyl, plastic primer, metalic silver paint, and clear lacquer | |
the_legend_of_yrag |
posted on 20th Oct 03 at 13:28 |
ive done heater vents left n right, dash surround door handles and tweeter holders and mfd cover. | |
stuyw |
posted on 20th Oct 03 at 13:20 |
the best way to tackle this is to take as much time as possible as the bits u are removing are easily broken | |
jamesw |
posted on 20th Oct 03 at 13:01 |
incufan2k3 :: i shouldnt think so, aslong as you aint left with a few screws afterwards ;) but mine was fine. | |
Graham |
posted on 20th Oct 03 at 12:52 |
luks extremly nice thats how i want mine to be done silver to go with the flame red exterior. jus the fact that if i take it off and put it on agen there is a chance of it rattling and that'll b annoyin | |
jamesw |
posted on 20th Oct 03 at 12:41 |
VoYtO LeViCh :: Where you get that zaust?? looks sweet. | |
jamesw |
posted on 20th Oct 03 at 12:39 |
tis pretty easy to do only pain is removing everthing to spray espesh the center bit with heater controls and also hard to spray into any enclosed places suck as door pockets etc whichout it splashing back out, i used star silver interia paint from halfords, if i remember rightly you get, primer, paint, and sealer, nt cheap but does a gd job, i dnt think silver would look out of place in a red car, lots of manufacturers these days producing cars are starting to add touches of silver to the interia looks miles better IMO | |
Voyto |
posted on 20th Oct 03 at 11:36 |
i got a red car but wanna do a silver interior. will this look odd? | |
bun |
posted on 20th Oct 03 at 11:30 |
interior looks sweet! how long and how hard is it to do though, I was going to do mine the other day but couldn't figure out where to start:o | |
jamesw |
posted on 20th Oct 03 at 11:06 |
http://www.ukhoster.net/carpics/5.jpg | |
Hazzle |
posted on 20th Oct 03 at 10:37 |
Anyone got pics of there resprayed interior? |