Ok I know i asked this last week but i have ran outa ideas. Basically the em light is coming on with the fault code "No Speed Sensor" or similar. I have checked all the wiring, all the wires are matched up from the dash to the loom. The speedo it self works fine. The dash has been in a couple of months now but it is only now that the fault is occuring. The ecu takes its feed from the speedo on the same wire that runs to the MFD, and if u press the 2 buttons on it, it displays the speed. So i know that the actual wire is getting the signal to the ecu so how come it keeps throwing up the fault??!?!?!
Pleeeeeeeeeeeez help :rolleyes: :thumbs:
|
