|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » 2.0 16v Gearlinkage..... » Post Reply
|
Dan_Corsa |
posted on 9th Sep 03 at 18:49 |
on the rear engine mount you have to lips that stick out 1 at each side u'll need to shave the right hand side of it,so it fits flush to the side of the gear box | |
jjcymru |
posted on 9th Sep 03 at 18:16 |
dan, what part of it did you shave? | |
K100RSA |
posted on 9th Sep 03 at 17:58 |
I tried using the corsa linkage and the cav linkage, but one was too long and the other too short, it wouldnt allow full selection of gears and would fould on the steering rack. | |
Dan_Corsa |
posted on 9th Sep 03 at 17:56 |
i just shaved the lip off the rear engine mount and put a bead of weld on the edge,no need to extend the gear linkage that way and i'm using the standard corsa linkage no mods to it and the f 20 box | |
jjcymru |
posted on 9th Sep 03 at 17:51 |
street, | |
Dave Hay |
posted on 9th Sep 03 at 16:59 |
can you not get away with flipping the standard corsa linkage round.... | |
K100RSA |
posted on 9th Sep 03 at 14:22 |
i used the 2l linkage and then just cut and shut it a bit, the right lentgh is in between the 2, so for example if one is 50 and the other is 30 then make it 40. but remember to get whoever cuts it etc to scribe a line along the link to ensure that the angle of the ends stays the same | |
street |
posted on 9th Sep 03 at 12:55 |
i used my corsa linkage and modified it by adding 15mm to both parts | |
jjcymru |
posted on 9th Sep 03 at 12:11 |
any ideas anyone? | |
jjcymru |
posted on 9th Sep 03 at 06:52 |
bttt | |
jjcymru |
posted on 8th Sep 03 at 19:27 |
What do you all do about the 2.0 16v linkage? |