|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » corsa exhausts » Post Reply
|
mattyboy199 |
posted on 7th Sep 03 at 15:14 |
It s a design fault the manifold mine hit even when is was nt lowered, when i lowered it, it was terrible, i rapped a rubber car mat round the beam zipp tied, its silent now, no probs. CHEAP AS CHIPS | |
Juha GSi |
posted on 7th Sep 03 at 11:04 |
meaning that push the rearbox connection as far it will go on the centre pipe connection. cos if its loose the whole exhaust will drop and hit the beam. | |
BabyBlade |
posted on 7th Sep 03 at 10:49 |
yeh i had the problem and it was loose so i redone it and was ok for a short while but now its doing it again, will have a look. when u say push it back do you mean push it towards the engine or push it towards the back of the car, because it its to forward the rubbers slide off the exhaust as there are no stops on the pegs to prevent the rubbers slipping. will pull the exhaust as far to the back of the car as i can | |
Juha GSi |
posted on 7th Sep 03 at 10:21 |
had the same problem, my rearbox had been slipping out from the connection, so try to push it if its loose. and push it back as far it goes. if your car is lowered much, might be something else... | |
Fraser Young |
posted on 7th Sep 03 at 10:21 |
Could get a couple wee bars welded half way up the centre section to the chassis... S'what I had done on mine... | |
Adam-D |
posted on 7th Sep 03 at 10:05 |
yes jus by the cat there is two hooks | |
BabyBlade |
posted on 7th Sep 03 at 09:52 |
do they have any hooks in the centre section to lift the exhaust up because i've got a problem with the exhaust hitting the rear beam and the entire section seems to be relying on the one hook at the back on the back box and the connection to the cat?? any ideas? |