yep thats right

so u take boot card off , take all lock off , weld a plate (on inside of boot) filler outside where holes r , smoothdown ,and paint ? is that right

quote:

---

Originally posted by Corsakid84
I WANNA DO MINE ASWELL!!! ON ME CORSA C!

---

just use fiber glass matting, which btw is used to fill in holes in bodywork anyway, then use some filler over it, it's easier and cheaper to do.

if u use f/glass filler and then just a light skim of isopon then it wont sink coz the f/glass filler wont sink and itll stop the filler from sinking

The more filler an fiberglassy stuff u use the more it'll look warped... after a month the filler will contract ever so slightly... Only notice it from like a few inches away, but, I'm like that, like it to be perfect!

its easy to wire in a solenoid popper,sum guys off the board sells them and u can see a fitting guide for them on.........
www.novamad.co.uk (brilliant site if u want to do this)

you need to weld a plate over the hole then fibreglass then filler

quote:

---

Originally posted by bluecorsasteve
i would have thought thats pretty obvious seth

---

u dont need to weld a plate behine the hole u can use fiberglass

Use filler an weld plate/spray... Bodyshops chare 200 quid for it, it really cost bout 60 quid... And for Corsa C you'll be lucky to find solenoids that work on the boot... Need to resort to a pull cable! :P

i would have thought thats pretty obvious seth

but if u want to open it again u gota get a solenoid connected up to the internal mechanism i think??

if you just want to remove the small lock hole you you weld a lplate on the inside, and outside and then fill in the hole and paint over it
best to get a pro to do it

I WANNA DO MINE ASWELL!!! ON ME CORSA C!

How impatient! :rolleyes:

ANYONE????

how do you do this??:boggle: