|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » de locking boot » Post Reply
|
Greasemonkey |
posted on 2nd Jun 03 at 22:27 |
yep thats right | |
Ben |
posted on 2nd Jun 03 at 21:47 |
so u take boot card off , take all lock off , weld a plate (on inside of boot) filler outside where holes r , smoothdown ,and paint ? is that right | |
glasgow_corsa_c |
posted on 1st Jun 03 at 11:01 |
quote: Mine is getitn done this week along with more bodywork | |
Blazer |
posted on 1st Jun 03 at 01:02 |
just use fiber glass matting, which btw is used to fill in holes in bodywork anyway, then use some filler over it, it's easier and cheaper to do. | |
STEvieXE |
posted on 31st May 03 at 18:08 |
if u use f/glass filler and then just a light skim of isopon then it wont sink coz the f/glass filler wont sink and itll stop the filler from sinking | |
Fraser Young |
posted on 31st May 03 at 13:24 |
The more filler an fiberglassy stuff u use the more it'll look warped... after a month the filler will contract ever so slightly... Only notice it from like a few inches away, but, I'm like that, like it to be perfect! | |
animality-gt |
posted on 31st May 03 at 13:14 |
its easy to wire in a solenoid popper,sum guys off the board sells them and u can see a fitting guide for them on......... | |
AdamF |
posted on 31st May 03 at 12:04 |
you need to weld a plate over the hole then fibreglass then filler | |
BabyBlade |
posted on 31st May 03 at 09:58 |
quote: Howcome no one said it then :P | |
Blazer |
posted on 31st May 03 at 02:33 |
u dont need to weld a plate behine the hole u can use fiberglass | |
Fraser Young |
posted on 30th May 03 at 15:12 |
Use filler an weld plate/spray... Bodyshops chare 200 quid for it, it really cost bout 60 quid... And for Corsa C you'll be lucky to find solenoids that work on the boot... Need to resort to a pull cable! :P | |
bluecorsasteve |
posted on 30th May 03 at 13:18 |
i would have thought thats pretty obvious seth | |
BabyBlade |
posted on 30th May 03 at 11:13 |
but if u want to open it again u gota get a solenoid connected up to the internal mechanism i think?? | |
bluecorsasteve |
posted on 30th May 03 at 11:04 |
if you just want to remove the small lock hole you you weld a lplate on the inside, and outside and then fill in the hole and paint over it | |
Corsakid84 |
posted on 30th May 03 at 10:14 |
I WANNA DO MINE ASWELL!!! ON ME CORSA C! | |
Patrick |
posted on 30th May 03 at 09:05 |
How impatient! :rolleyes: | |
vaux_red_corsa |
posted on 30th May 03 at 09:01 |
ANYONE???? | |
vaux_red_corsa |
posted on 30th May 03 at 08:43 |
how do you do this??:boggle: |