|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Wheel bearings for front hubs (c20xe conversion) » Post Reply
|
seanmooney |
posted on 25th Feb 15 at 12:15 |
Yeah its the new conversion hubs i need.. was looking everywhere on line to get new hubs and couldnt so after piecing information from researching on line im going to get the knuckles machined out to take the audi 90 bearing and then press in the hub flange so theres no porblems with the hubs shearing like ive been hearing about.. | |
random dav |
posted on 24th Feb 15 at 11:43 |
Its possible the hubs are worn and you may need to replace them. | |
random dav |
posted on 24th Feb 15 at 11:40 |
Which bits? Pic | |
seanmooney |
posted on 23rd Feb 15 at 23:07 |
I got a 64mm bearing and got it pressed into the knuckle but when I pressed in the hub flange it was still loose.. Turned out that the outside part of the hub flange was wore down. | |
random dav |
posted on 4th Feb 15 at 05:03 |
66mm seems too big, pretty sure they are 64mm. I'd go back and check others at the shop. | |
seanmooney |
posted on 3rd Feb 15 at 18:49 |
I got the bearing pressed out and the old bearing is 64mm diameter outer 34mm diameter inner and 37mm wide. | |
random dav |
posted on 3rd Feb 15 at 14:40 |
If the carrier has been machined the bearing hole will be 68mm to take vw bearings. If its smaller than 68m it has corsa bearings and machined hubs | |
seanmooney |
posted on 3rd Feb 15 at 07:40 |
I haven't a clue If they have been machined down.. | |
davegreen |
posted on 3rd Feb 15 at 06:40 |
depends on which hubs you have? | |
seanmooney |
posted on 2nd Feb 15 at 22:02 |
So bought a redtop conversion and it came with equal shafts and the hubs but I was taking the car off the trailer on sat past for painting and of course the bearing shit itself cause I had no shafts in to help support it.. |