|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Any Z18XE Corsa B's help needed.. » Post Reply
|
Valesidecc |
posted on 9th Sep 10 at 05:32 |
Thanks again.. | |
Bissmire |
posted on 8th Sep 10 at 11:46 |
I doubt it mate, a couple of people have used the x16xe sump so I guess that will be the 'easiest' way. I have the same engine as you, and I'm down about 60mm without any issues of cathching the sump. | |
Valesidecc |
posted on 8th Sep 10 at 09:49 |
Ye i understand that.. was just wondering if the same could be done with an 8v sump.. | |
Bissmire |
posted on 8th Sep 10 at 08:33 |
quote: I just explained what you have to do? If the sump is shallower, the pick up pipe must also be shortened. I'm not sure about the 8v but I assume it will be the same if i is shallower. The existing manifold will also hang long compared to the new sump. | |
Valesidecc |
posted on 8th Sep 10 at 08:30 |
Any one know if i could do the same thing using a standard corsa sump (from a 1.6 8v corsa) | |
Valesidecc |
posted on 7th Sep 10 at 13:14 |
Already had a custom manifold made up when i did the conversion.. | |
Bissmire |
posted on 7th Sep 10 at 11:24 |
You can fit a x16xe sump, but you need to modify the pick up pipe by shortening it I believe. You can also then use a decent x16xe manifold rather than paying stupid prices for the 1.8 manifold... | |
Valesidecc |
posted on 7th Sep 10 at 06:09 |
I recently dropped the car with a set of Spax RSX coilovers.. They are Set at the highest setting at the moment.. |