|
|
|
Not logged in [Login - Register] |
 |
You Are Not Registered Or Not Logged In |
|  |
|
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » sport now running on 2 cylinders!!! » Post Reply
|
| phil_fcuk |
posted on 10th May 10 at 18:19 |
PROBLEM SOLVED........ after many hours of scratching my head i was looking at the engine loom, followed it back and it wasnt sat properly and the heat had melted through some wires cause some to break and some to touch each other. fitted a new engine loom and job is sorted!!! thanks for the help tho guys! :D :thumbs: | |
| phil_fcuk |
posted on 10th May 10 at 13:54 |
im from wrexham, north wales mate. appreciate the offer, but im just about to leave to go get a new ecu kit from scrap yard. hopefully this will solve the problem. will update later... | |
| pteflint |
posted on 10th May 10 at 13:29 |
quote: were you from ive a spare ecu chip and transponder ya could try if ya local | |
| phil_fcuk |
posted on 10th May 10 at 12:44 |
its not bent valves either. its sparking on 2 and 3 but not 1 and 4 :( checked all the above, apart from ecu. i wanna leave that till last cause thats the most costly :( | |
| jamesy1990 |
posted on 10th May 10 at 08:52 |
mines done this turns out i had bent all 8 exhaust valves | |
| pteflint |
posted on 9th May 10 at 16:53 |
mine did something simerlar to that turned out to be ecu ,wish a new before a changed the head gasket plugs leads injectors fuel pump ect | |
| Ryan_G1 |
posted on 9th May 10 at 13:41 |
done the plugs? | |
| phil_fcuk |
posted on 8th May 10 at 22:25 |
no i have changed coil pack, thats it. when i take number 1 and 4 plug leads off they have no spark what so ever and its exactly the same when i change the coil pack! and yes, i also disconnected the ecu for an hour and half to reset it and its still the same! :( any more ideas?? | |
| Ryan_G1 |
posted on 8th May 10 at 22:14 |
quote: Its a coilpack engine :boggle: | |
| DERV-POWER |
posted on 8th May 10 at 21:10 |
probably ecu packed in by the sounds of it | |
| milky2010 |
posted on 8th May 10 at 20:40 |
quote: and the dizzy cap and rotary arm | |
| swill_omnibus |
posted on 8th May 10 at 20:26 |
Try changing leads, plugs and disconnect battery for an hour to also reset ECU. | |
| reidy22 |
posted on 8th May 10 at 18:25 |
changed plugs and leads???? | |
| phil_fcuk |
posted on 8th May 10 at 18:14 |
ttt | |
| phil_fcuk |
posted on 7th May 10 at 14:26 |
it started of as just a splutter in first gear, no it has come to only running on number 2 and 3. cylinders 1 and 4 have no spark getting to them. i have changed coil pack but with no change! i did paperclip test and it came up with coilpack 1 and 4 and MAP sensor. i have changed map sensor and coilpack but its still the same. i have now run out of ideas what it could be... |