|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Snapped a drill bit off inside a bolt » Post Reply
|
Sean-B |
posted on 28th Jan 10 at 21:37 |
Done it with a dremel, then drilled and re-tapped the hole. | |
harrisp |
posted on 28th Jan 10 at 17:10 |
Is the drill bit tight in the hole? I had a similar problem, hit the bolt a few times with a hammer then pulled the remaining part of the drillbit with a strong magnet. | |
Fro |
posted on 28th Jan 10 at 10:07 |
how comes you were trying to drill it so deep? | |
alan-g-w |
posted on 27th Jan 10 at 22:02 |
I'd try a widia tipped drill if there's no way of removing it. Where's the bolt located? | |
barneykarl |
posted on 27th Jan 10 at 21:33 |
Always a sod when this happens where is the bolt located, drilling into a broken drill bit will be a pain been there done that no easy answer you will have to try other ways to remove it can you heat it up and get grips on it. | |
SnK |
posted on 27th Jan 10 at 21:23 |
Is the bolt inset? Will monkey pliers not help you twist it out? What we do sometimes is get a mini hacksaw and cut a straight side into it, so you can get a flat head screwdriver on it and twist it out. Alternatively, spur point drill bit? | |
Sean-B |
posted on 27th Jan 10 at 21:16 |
Was drilling out a bolt, started with a 2mm drill bit. Was most of the way through and then stupidly something made me jump :mad: and the bit snapped in the hole. |