|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Cav ARB onto Corsa. How to? » Post Reply
|
alan-g-w |
posted on 9th Jun 09 at 19:34 |
quote: That's not the point. My understanding of it is that the ARB needs to be very tight against that rear beam to make it the most rigid it can be. If you're using jubilees you might not be getting it tight enough and so not making the most of it. | |
Gareth F |
posted on 9th Jun 09 at 18:09 |
They will probably snap as they go under stress mid corner :o | |
djgritt |
posted on 9th Jun 09 at 17:32 |
quote: Been alright for the last 3 months... Havent worked loose or moved atall either :thumbs: | |
alan-g-w |
posted on 9th Jun 09 at 17:20 |
Jubilees are nowhere near as strong as exhaust clamps. I'd be swapping them asap. | |
Gareth F |
posted on 8th Jun 09 at 22:12 |
I bought the 92mm exhaust clamps off ebay for £5 but thet dont sit well, using square plates under the beam instead of the curved section of the clamp. | |
djgritt |
posted on 8th Jun 09 at 21:53 |
I couldn't find big enough exhaust clamps in local shops so whammed on big Jubilee Clips instead - seems to work, until i source some proper clamps... | |
Jakey |
posted on 8th Jun 09 at 19:37 |
Ooo ta lads! Yeah i got all the rubbers, snapped one of the bolts but i only need 2 by the looks of things! Just need somebody with a pillar drill now! | |
Gareth F |
posted on 8th Jun 09 at 19:31 |
No i was missing my clamp so had trouble holding it still whilst drilling it. Used three sizes of drill bits which were old but i new they could handle it. Looking to get flat metalplates to use with the exhaust clamps so it sits better. | |
djgritt |
posted on 8th Jun 09 at 19:01 |
quote: I drilled mine easy with a Pillar Drill - piece of piss! Were you using crappy Bits? And did you stage it through using a pilot and gradually getting bigger? | |
Gareth F |
posted on 8th Jun 09 at 18:11 |
Heres the link to the original "How to" http://www.corsasport.co.uk/board/viewthread.php?tid=477327 | |
Gareth F |
posted on 8th Jun 09 at 18:03 |
Um drill a hole in each end of the bar (on the flat bits) bigger enough for some sturdy bolts. then get some fuck off big exhaust clamps ill find you site i got mine from. Then bolt it up :) | |
Jakey |
posted on 8th Jun 09 at 16:25 |
Got myself a rear ARB of a Cav SRi today, but have no idea how to fit it. |