|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » removing drive shafts from gearbox? » Post Reply
|
x14xe sport |
posted on 10th May 09 at 18:38 |
got shafts out ok now anyway, really should of had container for oil at the ready but hey its added some colour to the floor (amurtuers), will set on with linkage tommorow plus wiring??? not sure how to tackle this? is there a loom that goes round engine that i can just disconnect (it was like that on my 1.2 16v)? took inlet manifold of top and found what looks like this connector? | |
Richardhhha |
posted on 10th May 09 at 18:05 |
ok on the box you will find the selection rod, | |
x14xe sport |
posted on 10th May 09 at 17:45 |
ok didnt know how much greif to give it, wheres easiest place to disconnect gear linkage to get engine and box out in one? | |
Richardhhha |
posted on 10th May 09 at 17:42 |
leaver bar FTW... or long screwdriver with a hammer normaly pops them out.. NS shaft can be a git to get out sometimes | |
Markus |
posted on 10th May 09 at 17:11 |
just a little tug will do it dont go crazy though | |
x14xe sport |
posted on 10th May 09 at 16:24 |
how do i remove the driveshafts from the gearbox? car is 1.4 16v is it a case of pulling or are they held with a circlip or something cheers |