corsasport.co.uk
 

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » engine code help!! very important » Post Reply

Post Reply
Who Can Post? All users can post new topics and all users can reply.
Icon:
Formatting Mode:
Normal
Advanced
Help

Insert Bold text Insert Italicized text Insert Underlined text Insert Centered text Insert a Hyperlink Insert Email Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text
Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On
Post Options: Disable smileys?
Turn BBCode off?
Receive email notification of new replies?

scottboi

posted on 3rd Dec 08 at 21:00

lol dont worry ill have fire extinguisher handy lol


chris_gilly

posted on 3rd Dec 08 at 20:40

tis okay mate. id check for spark before petrol because you dont want to be igniting any fuel thats spilt!!! LOL


scottboi

posted on 3rd Dec 08 at 20:35

it just turns over. dosent even try to fire up just keeps turning over. ill have a check tomorrow after work and let you know what happened mate. thanks for all your help


chris_gilly

posted on 3rd Dec 08 at 20:21

so when you turn it over does it go to start or just turns over nothing at all? way to check is disconnect the fuel inlet to the injector/s and put the ignition on and if nothing happens then turn it over to see if petrol sprays out!be careful make sure theres no sorce of ignition nearby and you have a rag to soak it up


scottboi

posted on 3rd Dec 08 at 20:11

any chance it could be the fuel pump?? was thinking it myght not be getting enough fuel to fire up and causing funny errors on diog. coz the engine managment light dont flash when i put the key in but it stays on and says its fault code 85 immob wrong signal.


chris_gilly

posted on 3rd Dec 08 at 19:55

m true! well the only thing i can say is make sure its sparking by removing a plug then testing it.


scottboi

posted on 3rd Dec 08 at 19:52

bout 2 months ago so should be fine


chris_gilly

posted on 3rd Dec 08 at 19:27

not the fan belt the timing belt, might of lost teeth and its slipped. when was the belt last changed??


scottboi

posted on 3rd Dec 08 at 19:26

yh its sparking coz u cn hear it. and dont think belt slipped or would make horrible noise


chris_gilly

posted on 3rd Dec 08 at 17:58

is it sparking?? and is the timing ok?? the belt could of slipped!


scottboi

posted on 3rd Dec 08 at 15:27

checked everything fuel getting through just not firing its like something holding it back from firing up. did diog and still just comes uop with fault code 85 immobiliser wrong signal :s


luke85

posted on 3rd Dec 08 at 14:52

There is a fuse for the fuel pump, just check them all. if your time and date has reset then its lost power at some point, check all the wires are tight to the battery and check for any that have snapped off


scottboi

posted on 3rd Dec 08 at 14:41

engine turning over but not fireing up like the immobiliser stoping fuel getting through. fault code 85 is the only one showing up. it started fine this morning but went to go out again and it wouldnt start. the time and date been reset to 1992 but the battery has full charge. is there a fuse for the fuel pump or immobiliser i could check see if its blown?


luke85

posted on 3rd Dec 08 at 14:31

If the ECU light isnt flashing then its not the in built immobiliser, that code could have been stored for a while because it once didnt recognise the transponder.

It the engine turning over normally and just not starting?


scottboi

posted on 3rd Dec 08 at 14:28

bump


scottboi

posted on 3rd Dec 08 at 13:22

yh tryed that already. ecu light doesnt flash just stays on. bit of a pain as i used the car this morning and it was fine


johnhara1

posted on 3rd Dec 08 at 13:18

do you have a spare key?


scottboi

posted on 3rd Dec 08 at 13:17

bump


scottboi

posted on 3rd Dec 08 at 12:27

tryed to start my car and it wouldnt have none of it.
all the time and date was wrong ( 92) but the battery is fully charged.
did falut code as engine manegment light was on and come up with:

85 immobiliser wrong signal.

need help as i need my car for work.

anyone know what i got to do to get my key to match up to the immobiliser?