|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Inlet » Post Reply
|
Mr Turner |
posted on 15th Nov 08 at 15:43 |
so i can just block the two pipes off and leave the throttle body with the outlets open? | |
flame |
posted on 15th Nov 08 at 15:27 |
As vaux lad says extend the hose back into the expansion tank and leave the throttle body with no coolant pipes going to it. Either that or run the hoses through the throttle body but I find they split over time because of the tight angle they go through to get onto the throttle body. | |
Vaux Lad |
posted on 15th Nov 08 at 14:27 |
Originally it goes from the coolant pipe, through the small hose to the tb, through the tb to another hose which goes to the expansion tank. | |
Mr Turner |
posted on 15th Nov 08 at 13:16 |
is it alright to just block them both off? also if i block the pipes off do i have to block the two outlets off on the throttle body that the pipes used to go to? | |
Vaux Lad |
posted on 15th Nov 08 at 12:46 |
Join the pipes together beind the engine, or block them both off. | |
Mr Turner |
posted on 15th Nov 08 at 12:07 |
hi, when fitting a mantzel style inlet how do you connect the two pipes that were on the throttle body and also where do they go to? just confused as i cant remember where they go and due to the throttle body been in a different location none of the pipes will reach so what should i do? |