|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » corsa transpant wireing » Post Reply
|
sxi-kid |
posted on 28th Sep 08 at 13:12 |
sounds pretty straight forward to be honest, would i be able 2 use the gear box off the 1.2 16v? | |
Rybo |
posted on 26th Sep 08 at 00:21 |
quote: and blue is your temp gage im sure on the nova theres a brown/yellow for em light too on the nova engine loom there is a 6 pin plug with the 6 wires mentioned above..you may/maynot have to extend them to where your 1.2 ecu was, should be a pretty straight foreward swap to be honest when you take the corsa engine out take the little wiring loom off your starter loom/alternator that goes to your battery etc and put it on the 1.6 before you put it in (like you would on a redtop etc) and you need a water bottle with just the one outlet at the top (not sure if yours has or hasnt got one) | |
andyc1234 |
posted on 25th Sep 08 at 19:28 |
makes it easier really as the nova ecu is in the bay as well. | |
sxi-kid |
posted on 25th Sep 08 at 19:04 |
does that make it easier or harder te ecu being there? | |
ainsley_brader |
posted on 24th Sep 08 at 20:20 |
quote: yes as the ecu is on the engine not in the footwell! | |
andyc1234 |
posted on 23rd Sep 08 at 23:36 |
and the green one for the rev counter | |
andyc1234 |
posted on 23rd Sep 08 at 23:35 |
only 4 wires coming from the nova ecu. red one goes to 12v supply. black goes to ign on. red/blue is fuel pump and then the earth from anywhere on the engine | |
sxi-kid |
posted on 23rd Sep 08 at 22:59 |
not sure at all m8 | |
Mark B |
posted on 23rd Sep 08 at 22:11 |
is the wireing not different on a 1.2 16v?? same as the 1.0 12v? | |
Adam-D |
posted on 23rd Sep 08 at 20:39 |
the main harness is the same, the dial plug loom you will have to make, matcha nd extend wire for wire the 9 pin plug from the nova ecu to the plug in your footwell | |
sxi-kid |
posted on 23rd Sep 08 at 20:13 |
any luck yet mate?:) | |
James_H |
posted on 23rd Sep 08 at 19:30 |
Ah i see, but that sounds a beast. | |
sxi-kid |
posted on 23rd Sep 08 at 19:29 |
its got piper cams, venier adjustable pullys , lightened flywheel . boost valve , only got 70,000 and its only 100 of a mate so a lot easier:D could any do me a diagram of some sort please:thumbs: | |
James_H |
posted on 23rd Sep 08 at 19:24 |
Easy, only a few wires to connect. | |
sxi-kid |
posted on 23rd Sep 08 at 19:23 |
i have a 1.2 16v sxi corsa b and i have a 1.6 gsi 8v from a nova would it be hard to put in and can someone please help me with the wireing please :thumbs: |