|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » oil catch tank help » Post Reply
|
sumner2k3 |
posted on 8th Aug 08 at 23:35 |
ok cheers | |
Kenzie |
posted on 8th Aug 08 at 19:54 |
keep them blocked, will do no harm | |
sumner2k3 |
posted on 8th Aug 08 at 16:50 |
iv cut that s shaped pipe in half now and blocked both bits.. should i unblock them or is it ok to leave them blocked? | |
luke85 |
posted on 8th Aug 08 at 16:47 |
Dont worry about the smaller pipe, it passes through a hole no bigger than a pin on the rocker cover so you wont get any oil mist through that one, the engine breather is the one you have got going to the catch tank in your other post | |
dean101287 |
posted on 8th Aug 08 at 16:44 |
dont think so as the reason the other one does is because the way it routes. It comes out of the rocker cover and goes down to behind the throttle body. Pretty sure you just leave the s shaped one where it is. | |
sumner2k3 |
posted on 8th Aug 08 at 16:43 |
but the reson for having an oil catch tank is to stop the oil going into the inlet? so if you leave the small S shape pipe going from the rocker to the inlet, then oil is still going to pass from the rocker into the inlet aswel as going into the catch tank? | |
dean101287 |
posted on 8th Aug 08 at 16:26 |
the small one as in about 5mm? that just stays on the rocker cover and the inlet. its the other thicker one that needs to go to the catch tank iirc | |
sumner2k3 |
posted on 8th Aug 08 at 16:14 |
any one? | |
sumner2k3 |
posted on 8th Aug 08 at 15:59 |
Yesterday i made a quick oil catch tank which a few of you said i done it correctly but the really small bendy pipe that goes from the rocker cover to the inlet manifold should be blocked up aswel am i right? |