How can you tell if its top or bottom as its too noisy, Kitchenroll tube ive heard? oh an the cambelt hasnt been played with so doubt its overtightened been on there for 25k i think but who am i to say, i havnt a clue about it :lol:

Might put it through a cambelt and waterpump change with full service and a full flush. Just weird how it only happens at 1500 rpm - no higher and no lower. Not a fan of sportex but it was cheap and cheerfull so ive got a 3" scorpion on route to me :thumbs:

if its big end bearing, chrex on here has a bottom end for sale.
£40

over tensioned cam belt is a common cause of this.

big end bearings?

Depends where the knocking is comming from. Top end or bottom end

quote:

---

Originally posted by munk3yrac3r
Nope - Remus center pipe and sportex back box. K&n panel filter in a derestricted standard box. No other engine mods
:(

---

Bump :(

Nope - Remus center pipe and sportex back box. K&n panel filter in a derestricted standard box. No other engine mods
:(

you got a aftermarket exhaust manifold?

No one? :(

Noticed it over the last two months, its quiet on idle but as soon as i get to 1500rpm it starts knocking (not loudly) revs coincides with speed of knocking but then 1600rpm + it goes quiet and well......... normal. Any ideas anyone? Any help welcome :thumbs: