might aswell just rip everything out and figure out what to do with wiring etc later on, scrappy said i can take all wiring etc for £15 - £20

not sure on that one, probably bes to clean it up and measure the diameter. Swapping the whole interior loom will be a hefty job so be prepared, my advice is just get the parts you need and put a supply to them. A haynes manual would help you know how much you need. The interior loom goes everywhere.

But its your choice :)

found the thread for the arb size, but where abouts are they marked with the letters???

my car is basic model doesnt have extra wires needed for central locking etc so was going to take whole interier loom

I posted all the ARB sizes on here a while back but the search isnt much use. Never used the ARB on me LET and know others too who dont use it but thats up to you.

The central locking will go through the main car loom and you dont want to go stripping and swapping that. If I was you id pull the car loom apart in the scrappy and take out anything to do with the windows and central locking then add that to your car

anyone??? need to know asap as going scrappy tomorrow to strip car interior and don't want to waste time and money cheers

Need to know 100% what size the anti-roll bar is on a 1.4 sport v or w plate cant remember which??

Also its got elecy windows and C/locking wiring. What part of the wiring do i need from this to convert my 1.4 flair into using these bits. i know i need the door wiring , but what i really need to know is i know i need the loom from the car but my car is converted to c20let, is this wiring to do with the engine/conversion wiring separate to the loom that i need to add c/locking and the elecy windows to my car as ideally i dont want to mess with the engine loom.

Cheers