ive got a tubular 4 into 1 on my c16xe and had to have a reducer fitted so it married upto the cat.

be weary tho ive having problems now cus my lamber sensor is fucked and i cant seem to get another one that is the same and that works

[Edited on 19-01-2008 by gsirick]

Yeah, you need a x16/x14 front part of the exhaust system(cat etc)
As far as i know it will bolt straight to your center section, and it then should meet the x16 manifold.

so i need a x16xe janspeed manifold.
and a x16xe cat

and then im sorted ?

So fit an x16xe cat or decat pipe and it will all fit tgether??

I have the same problem wanting to know whats what.

The manifold fits the engine fine.
What it doesn't fit is the C16xe front pipe/cat, its too short.

Fit a front x16xe exhaust section and then it'll fit.

yes

Bottom ends are the same iirc


Just the head, inlet and emissions gubbins that are different between the two. Also the c16 uses an AFM. None of this makes a difference for what you wanted to know........ I stand to be corrected though.

[Edited on 18-01-2008 by gavin18787]

right i have a c16xe

i want a performance manifold

the only one i like is the janspeed one, unfortunatly it only fits the x16xe engine.

now i know i can put a bolt in the egr hole
but will it clear the c16xe sump?