|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » brake bias valve » Post Reply
|
Ben ev |
posted on 28th Dec 07 at 23:15 |
you could either swap for a master cylinder with 2 outlets which i think is the best option, or use a 2into1 union and join the rears before the bulhead and then split again afterwoods. | |
Cossie |
posted on 28th Dec 07 at 08:10 |
you need one for each pipe ! | |
mac1976 |
posted on 27th Dec 07 at 17:42 |
cheers so the ones a have seen there is a inlet and a outlet but the corsa has 2 pipes going to the back so how do you do this then :boggle: | |
csweatherston |
posted on 27th Dec 07 at 17:21 |
for a road car, once its set you wont want to adjust it again mac1976 ;) | |
Cossie |
posted on 27th Dec 07 at 17:06 |
I got mine from mtech germany as better to spent a bit of £££ than risking your life !! | |
mac1976 |
posted on 27th Dec 07 at 17:02 |
would it not be a pain in the rear if you want to adjust it tho | |
csweatherston |
posted on 27th Dec 07 at 13:28 |
only if you want the valve in the car.... | |
mac1976 |
posted on 26th Dec 07 at 21:14 |
thanks for this so a take it you got to run the brake lines in the car for this | |
Ben ev |
posted on 26th Dec 07 at 20:38 |
look on ebay for a bias valve mate. there easy to fit. they a a simple valve with a adjustable knob on the top which controls the amount of fluid to the rear brakes. no electronics involved, much like a bleed valve for a turbocharger. if you dont fit one and nail the brakes it'l go round in a circle as i twice found out doin over 80mph. not very nice when it does | |
Dave-Creations |
posted on 26th Dec 07 at 13:58 |
would u really need the bias valve tho??? its only the load adjuster on the back that needs to be altered to compensate. | |
csweatherston |
posted on 26th Dec 07 at 13:50 |
its advisable to fit a bias valve. | |
Dave-Creations |
posted on 26th Dec 07 at 13:32 |
u need to worry about it mate, i just got mk3 astragsi brakes on my corsa, you got nothin to wrry about, unless ur rear brakes are considerably bigger than the fronts. my fronts are 256mm calibra brakes, the back are 260mm. under heavy braking she will twitch on teh back end, yet to meet a corner in that situation tho :P | |
mac1976 |
posted on 26th Dec 07 at 13:10 |
am going to be putting disks on the rear of ma corsa and have been told to run a in car adjustable bias valve how do these work |