corsasport.co.uk
 

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Timing Belt/Power Loss » Post Reply

Post Reply
Who Can Post? All users can post new topics and all users can reply.
Icon:
Formatting Mode:
Normal
Advanced
Help

Insert Bold text Insert Italicized text Insert Underlined text Insert Centered text Insert a Hyperlink Insert Email Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text
Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On
Post Options: Disable smileys?
Turn BBCode off?
Receive email notification of new replies?

DannyParker

posted on 4th Sep 07 at 14:32

Yeah, the warmer the engine get the more noise it makes and it's quite embarrasing not to mention the fact when I'm going round a corner in low gear it struggles to move so sounds crap anyway.

I'll have a look at the bottom pully tonight and tensoin in the belt.


Thanks cpcrampton


cpcrampton

posted on 4th Sep 07 at 14:21

could do if it has jumped a tooth because of less tension.
have you checked to see if there is tension in the belt?
start your car and have a look at the bottom pully wheel the one you can see without removing any covers. and report back :thumbs: the noise your hearing could also be the bottom pully hitting the plastic case. sounds like a little supercharger. :)


DannyParker

posted on 4th Sep 07 at 14:17

Think it might be just the pully's to be honest as the belt is wavy as it runs along the pully's if you get me. Not to bad to fall off but enough to cause concern.

Could a dodgy timeing belt and tensioner cause as you say "no power at low revs?and slow to rev up until it gets up the revs a bit?"

Booking it in for the garage on Friday to replace the belt and pully's.


cpcrampton

posted on 4th Sep 07 at 14:13

have a look at the bottom pully and check if its vibrating. if so then its a keyway or key gone.


cpcrampton

posted on 4th Sep 07 at 14:10

your bottom pully which has alternator belt on has a key way in it which locks onto the timming pully which is behind the bottom pully then the little timming pully also has a key way which locks onto your crankshaft. im just guessing here but i think one of your key ways has sheared or broke. happened to me and i fixed it more than once. if its the crankshaft keyway itself your pretty much looking at a new crankshaft or engine. take it to vauxhall and tell them to have a look. if it turns out to be just the pully wheel and the inner timing wheel your ok just replace them.


DannyParker

posted on 4th Sep 07 at 13:19

Yep exactly that, hope you know what it is, it's really pissin me off to be honest!

[Edited on 04-09-2007 by DannyParker]


cpcrampton

posted on 4th Sep 07 at 13:03

do you have no power at low revs?and slow to rev up until it gets up the revs a bit?

[Edited on 04-09-2007 by cpcrampton]


DannyParker

posted on 4th Sep 07 at 12:39

Thanks Dave. No Air Conso hopefully if I look around I can get a quote for around 140.

Does anyone think the reason why i'm losing power could be to do with the timing belt and tensioner?


Dave A

posted on 4th Sep 07 at 12:02

kit price: £80
1.5 hours labour: £60

total should be about £140-160 depending if it has aircon or not.


DannyParker

posted on 4th Sep 07 at 11:45

First sorry for all the questions I've posted since I got my car :o

As my engine (X14XE) gets warmer there is a noise which gets louder near the timing belt. If I split the casing and wedge something inbetween it stops but I know thats isn't the solution. I've also noticed since this has happened power has started to drop, nearly stalling setting off. Only thing to rectify the power is putting the clutch down and red-lining it. That's only a short term solution as well as it loses power again within 5 minutes before having to redline it again, burning my clutch away. Have trouble starting it as well, this might be Idle Valve though but wondered if it's related.

Do you think it could be the timeing belt tensioner that's gone?

One guy quoted me £195 to replace the cam belt, timing belt, tensioner and I dont knwo about pulleys. does this seem a fair price?
.

:thumbs:

[Edited on 04-09-2007 by DannyParker]