|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Replacing IAC valve & TPS on a 1.6 16v » Post Reply
|
Ian |
posted on 19th May 07 at 19:30 |
Split and moved, many thanks for the contribution. | |
SHARPY |
posted on 19th May 07 at 11:31 |
ahh that aint my symptoms :( | |
Superlite Ltd. |
posted on 19th May 07 at 11:12 |
Engine managment ligt came on, check fault codes and it said | |
SHARPY |
posted on 19th May 07 at 10:54 |
thanx, bout time someone did a guide to this :D | |
Superlite Ltd. |
posted on 19th May 07 at 09:55 |
Yes, acording to EPC the throttle body bolts are torx head. Mine are 13mm bolt head.... | |
gsirick |
posted on 19th May 07 at 09:52 |
them fixings look different to mine bud, almost looks like on mine that theres 4 nuts fixed to the plastic inlet then the bolts go from the backside of the tb into the plastic inlet. | |
Superlite Ltd. |
posted on 19th May 07 at 09:47 |
To remove the ICA or TPS i would take the throttle body out. Saves you busting your knuckes trying to get into little spaces. The 4 bolts that hold the throttle body to the bracket & top inlet are removed from the front. See the photo of my ignition coil....you can see one of the throttle body bolts is half out. | |
gsirick |
posted on 19th May 07 at 09:43 |
when you undo the top inlet, where it connects to the tb bracket do u undo it from the back of the tb or the front? | |
Dave A |
posted on 19th May 07 at 09:40 |
well if you saw the shit that goes into my catch tank you would never connect your breather pipe into your inlet ever again, such a shit design. | |
Superlite Ltd. |
posted on 19th May 07 at 09:38 |
Thankyou Dave, i might do that | |
Dave A |
posted on 19th May 07 at 09:35 |
worth noting that is is also very worthwhile to block off the breather pipe on the black plastic tube round the back of the engine and vent that pipe to atmosphere or a catch tank, saves the tb and icv getting gunked up again ;) | |
Dave A |
posted on 19th May 07 at 09:33 |
good tutorial, makes it look far easuer than it sometimes is! | |
pow |
posted on 19th May 07 at 09:25 |
U2U Ian to get this in the tutorial section :cool: |