|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Wndow Washers not working » Post Reply
|
Joe |
posted on 15th Feb 07 at 17:40 |
Its where the motor goes into the bottle, little black rubber bung. Pull that out and it will probably be full of gunge. | |
2ltrjim |
posted on 15th Feb 07 at 15:42 |
will be th filter | |
ChrisBoom |
posted on 14th Feb 07 at 23:33 |
quote: Is that on the tank, or in the pump? I didnt clean any filters, just cleaned the outside of the tank. | |
Joe |
posted on 14th Feb 07 at 20:08 |
Did you take the little rubber filter out and clean that? They usually get a bit bunged up. | |
ChrisBoom |
posted on 14th Feb 07 at 19:51 |
Right, took the whole washer tank out, as it was manky anyway! Just remove the scuttle panel, loosen the bolt holding the tank down, then it pulls out from the arch. Gave it a scrub then, I wanted it clean :lol: | |
Dean_W |
posted on 14th Feb 07 at 11:19 |
Try not to buy a new one. They are bloody expensive. | |
nathy_87 |
posted on 14th Feb 07 at 11:09 |
check to see if any of the pipes or the little jets are blocked as my rear one is exactly the same and someone suggested it to me :) | |
ChrisBoom |
posted on 14th Feb 07 at 00:42 |
quote: Ahhh good, thats OK then. Thanks :thumbs: | |
CoastalCorsa |
posted on 14th Feb 07 at 00:42 |
i am breaking a corsa and have a working pump ! | |
Mo |
posted on 14th Feb 07 at 00:40 |
push the centre of the black clips to release the pin in the middle. You'll need new clips to put the arch back in. | |
CoastalCorsa |
posted on 14th Feb 07 at 00:39 |
is the car we are talkin about the caribic one in you garage ? | |
CoastalCorsa |
posted on 14th Feb 07 at 00:37 |
where the hell is the washer bottle on corsa gsi's is it not where they put it on the 1994 corsa merits - under scuttle panel | |
ChrisBoom |
posted on 14th Feb 07 at 00:28 |
Oh god, the inner arches :o | |
Mo |
posted on 14th Feb 07 at 00:19 |
p.s those instruction above are from a 1.6 16v sport engine bay | |
Mo |
posted on 14th Feb 07 at 00:18 |
just changed mine last month. mine did the same thing...no noise and no water. The motor is easy to locate but u need to take the passenger side wheel arch liner out and then the white water bottle. the motor is slotted into the bottle. | |
CoastalCorsa |
posted on 14th Feb 07 at 00:10 |
if its fine it will bleep | |
CoastalCorsa |
posted on 14th Feb 07 at 00:10 |
test loop impedance on the pump | |
ChrisBoom |
posted on 14th Feb 07 at 00:06 |
quote: Nope, its not working either. Ill get hold of a multi-meter tomorrow and test the line in, if thats fine, then ill get a new pump. | |
CoastalCorsa |
posted on 14th Feb 07 at 00:04 |
does the rear wash work [if you have one] | |
Joe |
posted on 13th Feb 07 at 20:59 |
Yes try a new pump, or at least check if there is a feed going to the pump. | |
ChrisBoom |
posted on 13th Feb 07 at 20:55 |
Hi, |