|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Getting an F20 into Neutral. » Post Reply
|
2ltrjim |
posted on 13th Feb 07 at 16:34 |
the linkage has 3 in and out positions (excluding left to right move ments)push it all the way in then pull it out one notch then insert your drill bit(has to be exact size) as u are pushing the drll bit in twist the linkage all the way to the left and you should feel the drill bit push firmly into place then the linkage will not move at all the you lock up your gear stick with a screwdriver (has to be a tight fit) then bolt linkage up simple as that. hope this helps contact me if youve any problems | |
Ben ev |
posted on 13th Feb 07 at 16:10 |
push the selector into neutral from the engine bay. disconect linkage. remove the bung in the selector housing. rotate the selector to the first/second plane and insert 4.8mm drill bit shank end first. hold gearskick in neutral over to first/second plane and insert drill bit through the white bit on the stick assembly. should be able to marry up 2 holes.tighten the linkage back up from underneath and remove drill bit. should now select all gears. | |
Vaux Lad |
posted on 13th Feb 07 at 15:35 |
Just push/pull the selector fork ontop of the box till it goes into neutral. | |
willay |
posted on 13th Feb 07 at 10:27 |
has the gear turret/select thing ontop of the F20 come off at all? | |
VegasPhil |
posted on 13th Feb 07 at 10:15 |
I'll have to have a look in there. I connected the clamp up, and wiggled the linkage, but it's still in gear. Maybe I should put some oil in it :o | |
Sly_SRi |
posted on 13th Feb 07 at 10:01 |
read in the haynes manual, it tells you in there. You need to get a drill bit and put it into a hole beside the linkage and then when its in neutral the bit will slot in, then you can connect the linkage up and remove the drill bit and it will be in the correct position. Consult the haynes manual though.... | |
CorsAsh |
posted on 13th Feb 07 at 01:42 |
Did you try a selection of torx bits, screwdrivers and sockets mate? | |
Robin |
posted on 13th Feb 07 at 01:29 |
can you move it at all? | |
VegasPhil |
posted on 13th Feb 07 at 01:13 |
I need the gearbox on my Corsa put into neutral so that I can set the linkage on it! Only thing is that I don't know how to get it there! |