Corsa Sport - for Vauxhall and Opel Corsa B, Corsa C and Corsa D

Not logged in [Login - Register]

You Are Not Registered Or Not Logged In

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Car keeps stallin » Post Reply

Who Can Post?

All users can post new topics and all users can reply.

Icon:

Formatting Mode:
Normal
Advanced
Help

Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On

Post Options:

Disable smileys?
Turn BBCode off?
Receive email notification of new replies?


gavin18787	posted on 9th Feb 07 at 21:49
	Well i had a simular problem with mine (1.2 8v jobbie ) it would run ok for a bit then it would splutter and cut out. This would usually happen after about 10 mins. You would then be unable to restart it for about 10mins. (usually happening at the worst possible moment/place :lol: :mad: :\| ) It turned out that it was cutting out because it was been over fueled. As the engine is fed more fuel when it is cold to get it running this is then reduced once it is warm. However if the sensor that is monitioring this is faulty the engine will over fuel and cut out. This is also explains why it wont restart straight away (as the engine thinks it is cool when its not). So I replaced the coolent temp sensor on mine and its been fine ever since :) Was about £4 from vaux :)
Superlite Ltd.	posted on 9th Feb 07 at 21:48
	quote: Originally posted by bigjim172000 Speed sensor? where is that? on transmission
bigjim172000	posted on 9th Feb 07 at 21:29
	x10xe, 1.0 3cyl jobby. When i ran my little diagnostics on it, when i start the car tickover goes between 1000-1200, then slowly it lowers to 800ish.
gavin18787	posted on 9th Feb 07 at 21:26
	what engine is it mate?
bigjim172000	posted on 9th Feb 07 at 21:08
	its working spot on, Was thinking maybe ISCV??? but then would it give me those codes?
Gregor	posted on 9th Feb 07 at 21:07
	huh ? I had the exact same symptoms and mine had snapped. Is it wirking spot on , not jumping about etc ?
bigjim172000	posted on 9th Feb 07 at 21:04
	speedo works fine tho???
Gregor	posted on 9th Feb 07 at 21:00
	Your speedo drive cable has snapped / disconnected
bigjim172000	posted on 9th Feb 07 at 20:54
	Speed sensor? where is that?
Superlite Ltd.	posted on 9th Feb 07 at 20:43
	Speed sensor?
bigjim172000	posted on 9th Feb 07 at 19:53
	Right i can start it if its been left a while and it will idle properly. Then if i drive it for 5 mins or so it wont idle and stalls. then i have to wait20 mins or so fr it to start again. Did a code read on it and got, - Incorrect RPM Signal. - No RPM Signal What am i looking at for being the fault.?