|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Need Help...Bike Carbs » Post Reply
|
sinnerboy |
posted on 5th Nov 06 at 12:38 |
Thanks Dave, your a gent :thumbs: | |
Dave A |
posted on 5th Nov 06 at 12:30 |
in short: | |
sinnerboy |
posted on 5th Nov 06 at 12:19 |
If you look at TV issue with the carb guide on it, page 122 it says "It needs to be connected to the ecu but the carbs will still work properly if not. Therefore, if you dont have an engine management system, dont connect anything to it. If however you have a standard engine management system, it can be connected but better results are achieved with and aftermarket system". | |
Dave A |
posted on 5th Nov 06 at 12:14 |
beat you to it ed :lol: | |
ed |
posted on 5th Nov 06 at 12:13 |
Oh, as Dave just said...... | |
ed |
posted on 5th Nov 06 at 12:12 |
ECU? You either use mechanical ignition (not possible on an X14XE) or electronic ignition which has a different ECU to the standard one. If you used the standard ECU then it would constantly be throwing up faults. | |
Dave A |
posted on 5th Nov 06 at 12:10 |
well if you keep your standard ecu most of the sensors wont be needed, cam sensor, intake air temp,m all the vaccum sensors and solenoids, egr, sai, lambda, icv, tps..... | |
sinnerboy |
posted on 5th Nov 06 at 12:05 |
Well according to them you dont need to connect anything to your ecu as they are carbs not throttle bodies..They said the car will run fine if you dont connect it but if you want you can..Well with the carbs, 4 branch, de cat, straight through stainless system im hoping about 20bhp but im not sure on that figure :o | |
Dave A |
posted on 5th Nov 06 at 11:03 |
I would also fit a different coilpack. the standard coilpack on these engines are amplified units and most ignition ecu's only work with non amplified. | |
Dave A |
posted on 5th Nov 06 at 11:02 |
quote: I really dont think that Bogg bros told you that you can use your standard ecu. you need an ignition only ecu, omex, lumenition, webber alpha, emerald.... all do them. | |
BarnshaW |
posted on 5th Nov 06 at 08:50 |
just out of curiosity what gain are you hoping to get out of these? | |
sinnerboy |
posted on 4th Nov 06 at 23:58 |
How come i need a different loom?The guys at boggs bros told me that all i need to do is buy there kit, make up a different alternator bracket and change the belt i think. They said i can use the standard ecu if i want but i'll get more out of the carbs if i get an aftermarket ecu..Im not up to speed with this sort of stuff so all help needed :( | |
Dave A |
posted on 4th Nov 06 at 22:48 |
you will need quite a few more bits, fuel lines, regulators, single outlet header tank, ignition system, loom, someone to set it all up..... | |
sinnerboy |
posted on 4th Nov 06 at 22:45 |
Hi all, |