lol....i cant fit a fag pack between mine and the floor :(
(mine is lowerd 80mm ish tho :()

does anyone elses flange not meet the centre pape very well??

Mine is to lol. Was driving up the road in my mates car an all you can see is a great lump of metal hanging down. He thought it was his cat lol

Yup, mines the same. I hear u can have it heated and bent up. Mines stupidly low, does my nut in.

i have the same one mate and its sits mental low!!! dinked it coming over a humpback bridge the other night! i've been thinking about removing my SAI for a while now but wasnt sure how to go about it.

the last time i looked, very low, it scraps goin over stoned driveways, why have u the same one?

How close does your manifold sit to the floor?

remove the sai system completely but leave the solenoid attached inc the vaccum lines. just block the vaccum hose that goes from the solenoid to the valve on the manifold using some sealant and a screw.

anyone?

Ive recently fitted a ProTech 4-1 manifold on to my corsa x16xe, but theres a bit hangin off where it would have bolted onto the old manifold (think its the secondary combination valve). It now makes a funny noise when i start it. Anyone else have this prob? And did anyone modify there heat shield cause mines isnt on and theres a fierce heat comin from it! Any help would be much appreciated!