do you ever stop posting on old threads

as the man just said The problem is that in Italy engine swapping is an illegal modification (and insurance can choose to not pay in case of accident),

so what would be the point

quote:

---

Originally posted by j1400
just put a whole c14se in the car, sure that'will take as much time?

---

Why change the entire engine while half of it is the same? If I had to swap the engine I'd put a 1.6 at least. The problem is that in Italy engine swapping is an illegal modification (and insurance can choose to not pay in case of accident), so retaining the block = much less problems and hassle.

And besides, I'm unable to easily carry around and fit a full engine of 100+ kg of weight.

just put a whole c14se in the car, sure that'will take as much time?

I don't think the limit is the single point injection. The old carburetor version of the C14NZ that can be found in older Opel Corsa A (I don't know about Vauxhalls), the 14NV, had 75 hp (with a better camshaft than the C14NZ and same valve sizes), compared to the 60 hp of the spi C14NZ and the 82 hp of the mpi C14SE. The single point injection is much like an electronically controlled carburetor.

By the way, since swapping the tops is maybe a bit too complex and relatively expensive, I was thinking about fitting only the C14SE camshaft (lift int/ext: 6.12/6.12 versus 5.6/5.2 of the one in the C14NZ, I don't know about duration!) instead.

[Edited on 22-01-2006 by SHIRAKAWA Akira]

i doubt you will get any gains IF the head lines up, since you will still be running single point injection

My idea was to fit the top of the C14SE retaining my single point injection. However, guys at Migweb told me a while ago that the C14NZ inlet manifold doesn't fit on the SE head, so I'll need, as you're saying, a new ECU, new pump, the MAF sensor, etc.

Is there any other problem involved in this partial swap? What about the ECU code? Will I need another key to start the engine?

Not sure on manifold fitting, but you'll most likely need a new ECU (from a Corsa SRi) and also a multi point injection fuel pump.

Hello everybody,

I am able to buy from a friend at a low price a complete C14SE engine head. My idea is to fit it on my C14NZ engine. The C14SE head has bigger valves and a better camshaft. For simplicity I would keep, for now, the C14NZ intake manifold and throttle body.

Will everything fit (expecially the C14NZ intake manifold on the C14SE head)? What about valve clearance (but I don't think it would be a problem, since the C14SE camshaft valve lift is still quite low)?

And, most importantly, will the standard C14NZ ECU work efficiently with the new engine configuration, without engine remap? Will there definitely be an improvement in power, over the C14NZ head?

Thanks in advance for your time.

[Edited on 21-01-2006 by SHIRAKAWA Akira]