if you wire up the ecu light wires, you can make the light on the dash flash to give you the code. if you search on internet there are a few sites which explain how to do this and also have a falut code list

think i need 2 get dave who wired it up, sort ecu wire out so he can plug in maybe get an idea where the problem is, its like pissing in the wind here :(

Its not ICV, plugs, dizy cap or rotor as there all new. I thought water temp sensor but that only shows up dodgy when the engine is cold then is fine when its warm? Waynes car is the other way round.

the light will come on if there is a fault, but it hasnt been wired so u can plug into it with tech 2, gonna get the lad who wired it up 2 sort it and get diag on it. not idle control as that was cleaned out few month bak not sure bout others

idle control valve, coolant temp senser, lambda probe, ermmmmmmm, cold be anything. you got light for engine managment wired up?

here we go!!!:lol::lol:

where's the icv dan? langey dont think so, as it didnt do what it did when the 1st problem happened.

problems started already wayne :(

is this nowt to dowith another prblem you had right at the start?

ICV??

been running fine, then all of a sudden 2nite it kept dropping below 900 revs and stalling, juddering at low revs in every gear, above 60 was fine no juddering etc etc.. any clues as wat this could be? i was scared of driving it home as i was abit away didnt want to do any damage.