yeh ur probs right ther, i was thinkin of tht because it handles the power so much beta, i had a bitch puttin the 0gauge wires in2 my chicks evo, really had 2 trim the cabling down a lot 2 fit in th amps terminals.

Id go for a Kenwood KAC-9152D amp to run two of them, they are £170. JBL is a bit extreme for two of them.

Once again, for an install using 0 gauge you would have to split it off in a dizzy ect to 4 gauge to even get it to fit the amp terminals. Id stick with 4 gauge for systems with this kind of power.

yup sounds good, but dont scrimp on the wiring tho, coz having all of the above with shitty wiring will fuck up the whole lot, try to buy atleast 4 gauge if u can, 0 gauge is beta tho!

JBL1201.1
787 Watts RMS x 1 channel at 4 ohms and ¡Ü 1% THD + N
Signal-to-noise ratio: 70dBA (reference 1 watt into 4 ohms)
1114 Watts RMS x 1 channel at 2 ohms, 14.4V supply and ¡Ü 1% THD + N
Dynamic power: 1339 watts at 2 ohms

Thinking of buying two of these for a boot install :



http://caraudiosecurity.com/shop/product/products_id/3444.html
Anyone recomend an amp for running them? Not got too much cash to spare at the moment, so if you could show me some cheaper ones I could get away with too!

Cheers, Chris