|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Car pulling all over with C20XE » Post Reply
|
Slammed_Corsa |
posted on 14th Jun 06 at 09:33 |
This post is a year old :o:o | |
45_CB |
posted on 14th Jun 06 at 08:26 |
Tracking | |
CorsAsh |
posted on 13th Jun 06 at 00:04 |
Did you fit new rubbers when you did the engine mounts? That might have an effect if they're worn out? | |
mark_r_333 |
posted on 12th Jun 06 at 23:45 |
whats the suspension set up like particularly at the back?? if its very spongy its possibly that the weight is coming off of the front end causing it to lift slightly, obviously making the steering feel very light and casuing it to pull all over the place, failing that, the suggestions above are possibilities | |
Graeme |
posted on 12th Jun 06 at 21:59 |
mine torque steers shit loads when u boot it in 1st and secong and that is an xe on bike carbs! | |
jamesvalver |
posted on 12th Jun 06 at 21:51 |
mine also torque steers alot in 1st and 2nd when u give it some | |
Mistamist |
posted on 2nd Jul 05 at 14:47 |
205mm width tyres make it torque steer even worse. | |
notts_v6 |
posted on 2nd Jul 05 at 13:53 |
cheers | |
TOMAS |
posted on 1st Jul 05 at 09:44 |
Unless tracking is spot-on with XE power in a corsa it pulls you all over the place. Mine was slightly out when i'd had the conversion & it was almost lethal in the wet when accelerating hard... | |
notts_v6 |
posted on 30th Jun 05 at 19:34 |
CHEERS LADS | |
Nic Barnes |
posted on 30th Jun 05 at 16:43 |
in the wet the other day, pulled out to overtake a wagon and it lit up the pass side wheel on the white lines in the centre of the road. its great fun, lol. | |
Rileysport |
posted on 30th Jun 05 at 16:05 |
cally shafts then :thumbs: | |
notts_v6 |
posted on 30th Jun 05 at 15:49 |
AHHHHHH. | |
Nic Barnes |
posted on 29th Jun 05 at 22:49 |
my xe tourque steers in 1st and 2nd. sometimes depending on road surface have to have a lot of right lock on. everything is tight, tracking bang on. it just does it. novas are the same | |
Will94 |
posted on 29th Jun 05 at 21:56 |
Yeah i'd say get the tracking checked, the extra weight over the front end is sure to have affected it | |
ed |
posted on 29th Jun 05 at 21:42 |
Did you have your tracking re-done after fitting the engine? | |
notts_v6 |
posted on 29th Jun 05 at 19:16 |
No i havent repladed track rod end, and everything is tight... | |
myke |
posted on 29th Jun 05 at 19:12 |
did you have to replace a track rod end at all? | |
Siberia |
posted on 29th Jun 05 at 18:22 |
if it is torque steer and i doubt it is.... equal length drive shafts will help... | |
notts_v6 |
posted on 29th Jun 05 at 18:10 |
Fitted the C20XE and the car is now pulling all over the place when i boot it.... |