|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Wont go into reverse- Help » Post Reply
|
Matt H |
posted on 15th Feb 05 at 19:14 |
Cheers guys :) | |
Rileysport |
posted on 15th Feb 05 at 08:37 |
i have a spare linkage for the gearbox top :D | |
Siberia |
posted on 15th Feb 05 at 08:28 |
are you positively certain you reset the linkage right? its either that or a fecked linkage.... | |
Ian |
posted on 14th Feb 05 at 22:06 |
Put it in first position and have someone hold it there, get under the car and loosen the linkage bolt and hold the linkage, then have them put it in third then tighten it up. | |
Matt H |
posted on 14th Feb 05 at 21:37 |
I will try this Adam. Thanks :thumbs: | |
AdamF |
posted on 14th Feb 05 at 20:45 |
can you get fifth? normally if youve set the linkage too far over so you get first in reverse you wont beble to get fifth cos it wont go over far enough | |
Matt H |
posted on 14th Feb 05 at 20:22 |
It goes into the positon for reverse on the gear sticjk but it seems to select 1st or 3rd | |
linz |
posted on 14th Feb 05 at 20:05 |
the linkage on top of the gear box is bad for wearing, sounds like wear and tear :( | |
BromleyBoy |
posted on 14th Feb 05 at 19:47 |
did you correct the gear linkage in the right place,gear lever held to the side and box in neutral? lift the gear gaiter up and make sure it goes far enough left and the lift reverse works | |
Matt H |
posted on 14th Feb 05 at 17:42 |
Yep its definatley tight. Was done after I reset the gear linkage. | |
Rileysport |
posted on 14th Feb 05 at 16:52 |
is the bolt on the clamp bit under the car tightened up properly... i had this it was like stirring soup till i tightened everything up nice :lol: | |
Matt H |
posted on 14th Feb 05 at 16:48 |
Right the blue corsa wont go into reverse. Its a 1.2 8V |