corsasport.co.uk
 

Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Engine revving eratically. Need help with ecu codes plz! » Post Reply

Post Reply
Who Can Post? All users can post new topics and all users can reply.
Icon:
Formatting Mode:
Normal
Advanced
Help

Insert Bold text Insert Italicized text Insert Underlined text Insert Centered text Insert a Hyperlink Insert Email Hyperlink Insert an Image Insert Code Formatted text Insert Quoted text
Message:
HTML is Off
Smilies are On
BB Code is On
[img] Code is On
Post Options: Disable smileys?
Turn BBCode off?
Receive email notification of new replies?

corsacant

posted on 16th Nov 04 at 20:35

was they cheap 2 fix?
also, the shitty thing is now making a noise when i put me foot down like it would if i was trying to plant it in 5th doing 15mph. but its doing for example, if im in 2nd at 15-20mph. anyone got any ideas?

[Edited on 16-11-2004 by corsacant]


Visionz

posted on 15th Nov 04 at 21:55

i had the same problem and mine turned out to be my injector was stuck open and my coolant temp sensor.

Thats on a 1.2 8v as well


Siberia

posted on 15th Nov 04 at 15:32

could be anything but i had a simular problem on m 1.28v and it turned out to be the temp sensor....


corsacant

posted on 15th Nov 04 at 15:27

right i disconnected the battery and reset the ecu, then did the fault testing again, i got exactly the same codes as befor, i checked the map sensor, thats seems 2 be fine, all the vacuum pipes seem ok. What i did notice is that when the car was flashing up the codes (without engine running) an odd noise was coming from the area below/near the water resevoir. as soon as the engine was started the noise stopped.


corsacant

posted on 14th Nov 04 at 22:46

cheers for all your help. The codes i get are the only obnes that make sense and they seem pretty accurate for the faults that i know i already have. The car was originally a 1.2ls but i dont know if that would be of relevance. I'll have a good look over me car tomorrow and post me progress. Cheers.


corb

posted on 14th Nov 04 at 16:06

no, top buzz site lists them all. well most.


ed

posted on 14th Nov 04 at 00:38

Wouldn't the fault codes be all the same to lower the cost of diagnostics equipment for Vauxhall garages... :boggle: Just a thought, I could be completely wrong :lol:


corb

posted on 14th Nov 04 at 00:35

im confused, as those fault codes are for a siemens ecu found on x18 and x20 engines, but the x16xe uses GM-multec mpi. which aint the same, i dont think :boggle:


ed

posted on 13th Nov 04 at 23:17

Air leak in vacuum pipe, air mass meter, lambda sensor or idle control valve. Reset the ECU to erase old faults before doing a test too - disconnect the battery for a few mins to discharge the backup source ;)


corsacant

posted on 13th Nov 04 at 23:14

Basically me cars revving its arse off and god knows why. Sometimes it runs ok then next thing the revs just start going up and down(never to the point of cutting out though) then other times the revs are just really high but at a steady rate(i'd guess around 2000-3000rpm). The car was originally a 1996 1.2 corsa ls but now has a 1.6(x16xe) corsa sport engine in. It has had the two original faults since i fitted the engine but the two new fault codes and the erratic revving has only came about in the past week. These are the original 2 fault codes before it started doing this which were:

0412 - secondary air solenoid
0325 - knock sensor

now i have 2 new fault codes on top of them(which i'm guessing could help me find out the problem). The thing is, the 2 new codes i'm getting don't seem to be listed on the fault code lists anywhere.

They are:
0514 - ?
0315 - ?

Does anyone have any idea what they could be or whats causing this?
also, how hard is it to fix the knock sensor and where is it located.
Any helps greatly appreciated

I can also be contacted at corsacant@hotmail.com

Cheers.