|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » harness mounts » Post Reply
|
TOMAS |
posted on 8th Nov 04 at 12:25 |
Yup - I run Sabelt 3" WRC harnesses with the aircraft buckle. There's no-way i'd mount them any other way than the above. In the rear I used one of the existing belt bolt holes and then drilled another hole besides (they are 4 point harnesses) and bought the reinforcement plates with tacked-on nuts which you just put on the underside of the car and screw your eye-bolt into - no real need to weld the plates on. I have done the same thing for the lap mounts on the transmission tunnel - under the exhaust shield on the underside of the car. | |
RichR |
posted on 8th Nov 04 at 12:20 |
agree with Tomas - Id feel much safer having it done properly - weld in some 6mm palte either sde - and sink in a mounting eye - it wont budge then | |
TOMAS |
posted on 8th Nov 04 at 11:23 |
^ exactly for 4 pointers drill hole in back seat shell area - put re-inforcement plate in and use eye bolt - its the best method by far. | |
Adam-D |
posted on 7th Nov 04 at 19:13 |
i dont like that as its not a tested mounting pint and is questionble weather it can take a crash force | |
GED2.0CORSA |
posted on 7th Nov 04 at 18:32 |
get a rear strut brace and do it that way mate , thats what im thinkin about doing !! | |
Korsa |
posted on 7th Nov 04 at 14:58 |
get like a roll cage thing and run it off there.... | |
Adam-D |
posted on 7th Nov 04 at 11:56 |
just make the install around the harneses | |
vaux_red_corsa |
posted on 7th Nov 04 at 11:45 |
yeah thats where ive got them mounted already but i was jst wonderin if i could change the postion of them to fit my new ice install but i cant so it is back to the drawin board for the ice install to move things abt a bit | |
Adam-D |
posted on 7th Nov 04 at 11:41 |
mount them where the rear seat belt goes in the bench | |
Korsa |
posted on 7th Nov 04 at 11:34 |
mounting on the rear pillar is not safe @all | |
ed |
posted on 7th Nov 04 at 11:34 |
Three point harnesses can be fitted to the C pillar. Four point harneses need to be fitted to the two seat belt mounting points on the rear bench. | |
Fraser Young |
posted on 7th Nov 04 at 11:30 |
i presume u can, as with 4 points usually one goes to top mount and one to bottom anyway | |
vaux_red_corsa |
posted on 7th Nov 04 at 11:27 |
yeah it is:) | |
Fraser Young |
posted on 7th Nov 04 at 11:25 |
take it it's 3 point harnesses u have? | |
vaux_red_corsa |
posted on 7th Nov 04 at 10:58 |
can you mount the strap that goes to the rear of the car on the top seat belt mountin in the back??:) |