|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » IT WONT START - HELP!! » Post Reply
|
M559 WOW |
posted on 31st Oct 04 at 23:38 |
wel thanks everyone who helpd me on this problem, the car now starts after my dad and i wired in the blak box etc. so it runs but only on 3 cylinders for sum reason, oh wel. made sum progress atleast! | |
J100RSA |
posted on 31st Oct 04 at 23:00 |
adam ur gettin good at the immobilizer problems :lol: | |
Adam-D |
posted on 31st Oct 04 at 18:42 |
u2u sent | |
M559 WOW |
posted on 31st Oct 04 at 17:55 |
i have got the key off the 'other car' and the rectangular blackbox that sits underneath the ignition barrel. i also have the loom from the othercar so all i need 2 do is pik out the wires that r to do with this coded key thing and then wire them in2 my loom it looks like | |
Adam-D |
posted on 31st Oct 04 at 17:43 |
theres no way of bypassing the immob | |
Darren |
posted on 31st Oct 04 at 15:59 |
quote: u2u lee mitchell, he did mine | |
M559 WOW |
posted on 31st Oct 04 at 15:42 |
is there anyway of by passing this immobiliser as i havnt got a chip on my car so fitting this one from the gsi would mean having to wire it into my loom which i would rather not do! | |
M559 WOW |
posted on 30th Oct 04 at 18:59 |
i replaced the wiring loom that runs the engine and the ecu box and everthng down in the drivers footwell, but i havnt changed anything to do with the chip or anythn | |
AdamF |
posted on 30th Oct 04 at 18:49 |
if the ecu light is flashing its more than likely the chip. did you replace the thing on ignition barrel and chip in car from the car you got the engine from? | |
Rhino |
posted on 30th Oct 04 at 18:45 |
It to do with the ECU and the Chip you have in your Key. | |
M559 WOW |
posted on 30th Oct 04 at 18:40 |
Just finished putting a x16xe engine into my 1400 8v sri corsa, came to start it and nothing! put the ignition on and the ecu light starts flashing and nothing happens when i try to turn it over. Ive plugged the fault finder thing into it to try to see whats wrong and it comes up with code 12 which apparently means thers no faults! |