|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » c16xe/x16xe without upper-lower inlet-manifold? » Post Reply
|
Greasemonkey |
posted on 11th Oct 04 at 08:42 |
It will be sat either between the block and inlet trunking of between the plastic water pipe and block, like siberia said just drive it | |
Siberia |
posted on 10th Oct 04 at 22:31 |
quote: i can imagine... i put a c16xe lump in there last week and its tight enough i can imagine a c20xe being tighter again.... @ magic monkey... unless u have have droped the tool into the inlet itsself i wouldnt bother going taking the maanifold off to find it.... just drive the car..... it will soon fall out:) | |
MoNkEy MaGiC |
posted on 10th Oct 04 at 22:23 |
the haynes manual says i can undo just the top mounting bracket and pivot the alternator to the side! | |
Adam_B |
posted on 10th Oct 04 at 22:18 |
its easier than removing the inlet fanimould on my 2 litre :) | |
Siberia |
posted on 10th Oct 04 at 22:16 |
quote: thats not the most easyest thing to do either :look: | |
Adam_B |
posted on 10th Oct 04 at 22:15 |
taken the alternator out ? | |
MoNkEy MaGiC |
posted on 10th Oct 04 at 22:13 |
as above need some advice/pics of what the c16xe looks like without the upper and lower inlet manifold on?? |