|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » Another question on rear disk conversion » Post Reply
|
JJ |
posted on 8th Oct 04 at 10:31 |
No probs :) | |
masterx81 |
posted on 8th Oct 04 at 10:29 |
quote: Ok!!! Now i call some scrappy to get the material... Very thanks for the help:thumbs::thumbs::thumbs: | |
JJ |
posted on 8th Oct 04 at 10:19 |
Correct, just make up the length you need from the rubber flexi hoses to the rear calipers ;) | |
masterx81 |
posted on 8th Oct 04 at 10:16 |
Sorry, i'm italian (i'm not speak english very well...) and i'm not explained well... for rigid hoses I meant copper hoses (green painted hoses)... sorry... So i can only route them to the caliper? | |
JJ |
posted on 8th Oct 04 at 09:58 |
No need to use the rigid (braided) hoses, the origional ones will be fine... just make up the break lines to the rear calipers with copper break pipe :) | |
masterx81 |
posted on 8th Oct 04 at 08:47 |
quote: Ok... I add this cable to the "buying list":thumbs: I have already done on time the process to relieve the tension on the spring, because my rear drums locks the wheel, but i think that the valve is damaged... I think that at the rear brake conversion mount a new one... With the work of the rear disk and front disk I've in mind to replace the flexible hoses (with aereo ones) and master braking unit, to have a 'like new' system... But the rigid hoses need modifications? Or the standard of the corsa works well? Very thank for the patience... | |
JJ |
posted on 8th Oct 04 at 08:37 |
u will need the main standard corsa cable and a 1987 short nova cable... The bias may need adjusted if the car is lowered... just release the tension on the spring at the bias valve... | |
masterx81 |
posted on 8th Oct 04 at 07:23 |
OK! | |
lee mitchell |
posted on 8th Oct 04 at 07:11 |
u wont need to alter it mate it will be fine | |
masterx81 |
posted on 7th Oct 04 at 23:27 |
Ok, my car have a load dependant valve.... | |
Adam_B |
posted on 7th Oct 04 at 23:20 |
possibly, its not a big job to change the bias tho... | |
masterx81 |
posted on 7th Oct 04 at 23:12 |
Hi to all... Only in this days I have find this forum and the MIGweb forum... |