|
Not logged in [Login - Register] |
You Are Not Registered Or Not Logged In |
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » alpine digital amp over-current » Post Reply
|
RobHayes |
posted on 15th Sep 04 at 16:49 |
could do but not 100% sure on the reciept location, and i've had it a month now. altho i might be able to explain the situation and maybe get them swapped. il try. also get pics of my install up when i get it fully finished :thumbs: | |
Richie |
posted on 14th Sep 04 at 16:21 |
booger :(, cant you send the sub you've already got back and say u accidentally bought the wrong one? Ur running it at half power :( | |
RobHayes |
posted on 14th Sep 04 at 16:03 |
could do, but that would mean a whole new boot install :( and i like the one i've just done | |
Richie |
posted on 13th Sep 04 at 22:53 |
or just buy another dual 2 ohm sub, and have two subs :D | |
RobHayes |
posted on 13th Sep 04 at 17:24 |
i got it sorted. cos i got dual 2ohm sub, when they are wired in parallel, they are trying to draw 1ohm out of the amp which it cant do and therefore cuts off. | |
kev_corsa |
posted on 12th Sep 04 at 15:46 |
dual 4 ohm and the digital amps can drive into a 2ohm load so u should b ok with that dude | |
RobHayes |
posted on 12th Sep 04 at 13:37 |
not sure, its the 1042D, which i think is the 2ohm? i think i've just clicked as to the problem, with the amp giving out 4ohms or summat like that :S | |
Richie |
posted on 12th Sep 04 at 12:00 |
hang on bud, did you get the dual 4 ohm or the dual 2 ohm version of the 10 inch sub u got? | |
Richie |
posted on 12th Sep 04 at 12:00 |
Try wiring it up like it is in the picture bud. | |
RobHayes |
posted on 12th Sep 04 at 11:59 |
thats kinda how it is, but instead of having the junction between the 2 wires on the sub, i got them connected before that in a seperate connection box thing. does this make a difference and should i change it to like the picture? | |
Richie |
posted on 12th Sep 04 at 11:37 |
You should wire it like this mate: | |
RobHayes |
posted on 12th Sep 04 at 11:31 |
well i got an alpine 10" dual voice coil sub, but the amp only has 1 output channel so i put 2 wires into each of the terminals to run the 2 voice coils in parallel. could this be why?? i followed the wiring diagrams on the instructions :( | |
kev_corsa |
posted on 11th Sep 04 at 18:29 |
check to see if your output terminals are shorting somewhere | |
RobHayes |
posted on 11th Sep 04 at 18:22 |
hi guys, help desperatly needed. i got an alpine MRD-M500 digital amp, and it cuts off when u turn it up, bringing up the error code E-3 which, according to the manual, means over current. |