|
|
|
Not logged in [Login - Register] |
 |
You Are Not Registered Or Not Logged In |
|  |
|
Corsa Sport » Message Board » Help Zone, Modification and ICE Advice » xe coversion gear linkage » Post Reply
|
| astravanman |
posted on 16th Aug 04 at 14:28 |
U WELD AN EXTRA 10MM ON THE ARM OFF THE LINKAGE AND ON THE CURVE OFF IT MATE | |
| corsaandy |
posted on 16th Aug 04 at 12:08 |
where did u get an extra piece from did u just use another gear linkage bit from another car | |
| Joff |
posted on 15th Aug 04 at 23:56 |
With the MTech kits you need to add length to the linkage - cut it in half and weld an extra piece in. | |
| gsi-gaz |
posted on 15th Aug 04 at 23:13 |
no on the gear box mount u can shave the lip off, but make sure u do it enough or it wont go into gear, any more info needed on this, u2u beardy! | |
| corsaandy |
posted on 15th Aug 04 at 22:18 |
i am about to do a xe conversion to my corsa and was wondering what has to be done to join up the gear linkage i have heard you have to weld abit onto the end of the linkage but which end the gearbox or gear lever end? Also is it possible to use the gear lever end bit from another car, i read somewhere think it was mig that you can use an astra lever bit and all you have to do is shorten it which is alot easier than extending it, is this true? |